Philips HTR5000 User manual - Page 17

English Getting Started Step 1: Inserting batteries into the remote control 3 1 2 1 Open the battery compartment. 2 Insert two batteries type R06 or AA, following the indications (+-) inside the compartment. 3 Close the cover. Step 2: Switching on/off After completing all the connections, connect the AC power cord of the AV receiver to the wall outlet. Switching to an active mode G Press the SOURCE control to select : DISC 6CH ™ DISC COAX ™ DISC OPTI ™ FM ™ AM™ AUX ™ TV ™ DISC 6CH .... OR Press TV, DISC, TUNER or AUX on the remote. Using the remote control to operate the system 1 Aim the remote control directly at the SOUND remote sensor (iR) on the front panel. 2 Select the source you wish to control by pressing one of the source select buttons on the remote control (for example TV, TUNER). TV DISC TUNER AUX DISC DVD MENU VOL SYSTEM 3 Then select the desired function (for example S, T). STOP PLAY/PAUSE RESUME SURROUND SOUND NIGHT MUTE REPEAT REPEAT SLEEP DIM CAUTION! - Remove batteries if they are exhausted or if the remote is not to be used for a long time. - Do not use old and new or different types of batteries in combination. - Batteries contain chemical substances, so they should be disposed of properly. Switching to standby mode G Press STANDBY ON (B). ➜ The display screen will go blank. Step 3: Setting the speakers You can adjust the delay times (center and rear only) and volume level for individual speakers. These adjustments let you optimise the sound according to your surroundings and setup. IMPORTANT! Press SURROUND button on the remote to select Multi-channel (DOLBY DIGITAL / DTS/MOVIE/ MUSIC/ PRO LOGIC) surround mode before adjusting the speaker settings. 1 In active mode, press and hold PROG for five seconds to enter system setup. 2 Press S / T on the set to select one of the following options : CENTER DELAY, REAR DELAY, TEST TONE or MENU OFF. 001-003_HTR5000_01_Eng3 14 17 10/3/05, 2:30 PM 8239 300 30571