Philips MANT901 User Manual - Page 7

Mast Assembly Mast not included

Get Philips MANT901 PDF manuals and user guides View all Philips MANT901 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 7 highlights

Assembly EN • Attach one 46˝ Element to hole A in VHF Boom-B. • Attach one 50˝ Element to VHF Boom-B. Repeat each steps with second boom for VHF Boom-B. • Insert VHF Boom-B into VHF Boom-A and secure using 1-1/2˝ screw and lock washers. Repeat steps for 2nd boom as well. • Attach tubing brace to rear of VHF Boom with 11/2˝ screws and wing-nuts. • Slide UHF Boom through center slot of VHF Boom support block until hole A of UHF Boom aligns with hole B of VHF Boom. Secure with 1-1/2˝ screw and wing-nut. • Attach phasing wire and lead-in wire to UHF antenna using 3/4˝ screws, washers, and wing-nuts. • Insert end caps at ends of all booms. Mast Assembly (Mast not included) • Assemble U-bolts to cross pieces. • Use saddle on center of boom. 7

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
7
EN
Assembly
• Attach one 46˝ Element to hole A in VHF Boom-B.
• Attach one 50˝ Element to VHF Boom-B.
Repeat each steps with second boom for VHF Boom-B.
• Insert VHF Boom-B into VHF Boom-A and secure
using 1-1/2˝ screw and lock washers.
Repeat steps
for 2nd boom as well.
• Attach tubing brace to rear of VHF Boom with 1-
1/2˝ screws and wing-nuts.
• Slide UHF Boom through center slot of VHF Boom
support block until hole A of UHF Boom aligns with
hole B of VHF Boom.
Secure with 1-1/2˝ screw
and wing-nut.
• Attach phasing wire and lead-in wire to UHF antenna
using 3/4˝ screws, washers, and wing-nuts.
•
Insert end caps at ends of all booms.
Mast Assembly (Mast not included)
•
Assemble U-bolts to cross pieces.
• Use saddle on center of boom.