Philips MANT901 User Manual - Page 8
Lead-In Wire, Band Separator - tv antenna
View all Philips MANT901 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
EN Assembly • Assemble U-bolt assemblies loosely to antenna. • Insert mast through U-bolts. • Tighten U-bolts securely. All U-bolts should be on Wall one side of mast. Drip Loop To Signal Splitter • Attach mast standoff to mast. • Insert wire in standoff and tighten with pliers. • Power lines should be as far away as possible. • Assemble U-bolts in wall mounts with lock washers and nuts. • Secure mounts to wall with wood screws. • Separate mounts by at least two feet. • Insert mast with assembled antenna through both U-bolts. • Face antenna toward TV station. • Tighten U-bolts securely. • Wall mounts and chimney mounts are not included. Lead-In Wire • Attach lead-in wire to house with screw-type standoffs. • Tighten standoffs with pliers after wire is installed. • Avoid sharp bends in lead-in wire. • Form drip loop where wire enters wall. • Wall mounts not included. • Mounts, mast and standoffs are not included. Band Separator • Attach band separator to appropriate terminals on TV set. • Attach antenna lead-in wire to band separator. • An FM set or second TV set may be attached to sec- ond output of band separator. 8