Philips MCD288 User manual - Page 39

Clock/Timer English Clock setting See "Preparations-Step 2: Setting the clock". Timer setting ● The system can be used as an alarm clock, whereby the last selected source is switched on at a set time (one time operation).The clock time needs to be set first before the timer can be used. 1 In standby mode, press and hold SLEEP/ TIMER for more than three seconds. ➜ "TIMER SET" is displayed briefly.Then, the hour digits flash on the display panel. 2 Press VOLUME -/+ (VOL +/- on the remote) to set the hours and SLEEP/TIMER to confirm. ➜ The minute digits flash on the display panel. 3 Press VOLUME -/+ (VOL +/- on the remote) to set the minutes and SLEEP/TIMER to confirm. ➜ "TUN", "DVD" or "USB" flashes. 4 Press VOLUME -/+ (VOL +/- on the remote) to select your desired source. 5 Press SLEEP/TIMER to complete the setting. ➜ Display shows . To deactivate the timer ● Press SLEEP/TIMER again. ➜ disappears. Sleep timer setting The sleep timer enables the system to switch off by itself after a set period of time. 1 Press SLEEP/TIMER on the remote control repeatedly to select a preset time. ➜ The selections are as follows (time in minutes): OFF ™ 15 ™ 30 ™ 45 ™ 60 ™ 75 ™ 90 ™ 105 ™ 120 ™ OFF ➜ "SLEEP XX" or "SLEEP OFF" is displayed. "XX" is the time in minutes. 2 When you reach the desired length of time, stop pressing SLEEP/TIMER. ➜ Display shows . To deactivate the sleep timer ● Press SLEEP/TIMER repeatedly until "00" is displayed, or press STANDBY-ON y (STANDBY y on the remote). ➜ disappears. 39