Philips PPX5110 User manual - Page 20

The CE marking certifies, that the product meets the main requirements of the European Parliament and Council directives 2014/35/EU, EN55032:2012+AC:2013(Class B), CISPR 32:2012, EN61000-3, IEC61000-4, EN55024, EN55024/ A1, Draft EN 301 489-1, Draft EN 301 489-17, EN 300 328, EN 62311:2008, EN 60950/A1, EN60950/A2, EN60950/A11, EN 60950/A12 on information technology equipment, regarding safety and health of users and regarding electromagnetic interference. The declaration of compliance can be consulted on the site www.picopix.philips.com. Preservation of the environment as part of a sustainable development plan is an essential concern of X-GEM SAS. The desire of X-GEM SAS is to operate systems respecting the environment and consequently it has decided to integrate environmental performances in the life cycle of these products, from manufacturing to commissioning use and elimination. Federal Communications Commission (FCC) Statement: You are cautioned that changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the device. This device has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This device generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this device does cause harmful interference to radio or television reception, which can be determined by turning the device off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Adjust or relocate the receiving antenna. • Increase the separation between the device and receiver. • Connect the device into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1 this device may not cause harmful interference; 2 this device must accept any interference received, including interference that may cause undesired operation. FCC RF Radiation Exposure Statement: This transmitter must not be co-location or operating in conjunction with any other antenna or transmitter. This device complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This device should be installed and operated with a minimum distance of 20 centimetres between the device and your body. Canada Regulatory Compliance This device complies with Industry Canada CAN ICES-3 (B)/NMB-3(B) RSS-Gen & RSS-247 statement: This device complies with Industry Canada RSS standard(s). Operation is subject to the following two conditions: 1 This device may not cause interference, and 2 This device must accept any interference, including interference that may cause undesired operation of the device. RF Radiation Exposure statement: The device meets the exemption from the routine evaluation limits in section 2.5 of RSS102 and users can obtain Canadian information on RF exposure and compliance. This device should be installed and operated with a minimum distance of 7.8 inches (20 centimetres) between the device and your body. 20 Philips · PPX5110