Pioneer A-35R Owner's Manual - Page 9

Rear Panel ]

Page 9 highlights

English [ REAR PANEL ] 1 23456789 0- PANEL FACILITIES SPEAKERS RB L SIGNAL GND PHONO TUNER L CD LINE/ TAPE 1/CD-R/MD SURROUND BACK REC PLAY TAPE 2 MONITOR REC PLAY L R IN R IN IN IN OUT IN OUT IN ª ··ª RA L CONTROL OUT ATTENTION: NE RELIEZ PAS AL'APPAREIL DE TELEVISION OU AU MONITEUR. AC INLET AC OUTLETS CAUTION: DO NOT CONNECT TV SET OR MONITOR. SWITCHED TOTAL 100W MAX UNSWITCHED 100W MAX AC 120 V 60 Hz =~ ! @ # 1 GND (Turntable ground) terminal 2 PHONO terminals 3 TUNER terminals 4 CD terminals 5 LINE/SURROUND BACK terminals 6 TAPE 1/CD-R/MD REC (OUT) terminals 7 TAPE 1/CD-R/MD PLAY (IN) terminals 8 TAPE 2 MONITOR REC (OUT) terminals 9 TAPE 2 MONITOR PLAY (IN) terminals 0 SPEAKERS B terminals (Right channel) - SPEAKERS B terminals (Left channel) = SPEAKERS A terminals (Right channel) ~ SPEAKERS A terminals (Left channel) ! CONTROL OUT jack (see page 6) This jack is for output of control signals when operating other components bearing the Î mark with the attached remote control unit. @ AC INLET jack Connect power cord to here and an AC wall socket, or the AC outlet of an audio timer. If you are going to be away from home for a long period of time, disconnect the unit from the wall socket. NOTES: ÷ If you use an other power cord than provided, we cannot assume the liabilities in what may occur as a result of it. ÷ (The provided power cord has a current capacity of 7 A.) # AC OUTLETS [SWITCHED TOTAL 100 W MAX] Power supplied through these outlets is turned on and off by the amplifier's POWER ON/OFF switch. Total electrical power consumption of connected equipment should not exceed 100 W. [UNSWITCHED 100 W MAX] Power flows continually to this outlet, regardless of whether the amplifier is switched ON or OFF. Electrical power consumption of the connected equipment should not exceed 100 W. NOTES: • Do not connect appliances with high power consumption such as heaters, irons, or television sets to the AC OUTLETS in order to avoid overheating or fire risk. This can cause the amplifier to malfunction. • The equipment should be disconnected by removing the mains plug from the wall socket when not in regular use, e.g. when on vacation. 9 En

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24

9
<ARE7263>
En
English
[ REAR PANEL ]
@
AC INLET jack
Connect power cord to here and an AC wall socket, or the AC
outlet of an audio timer.
If you are going to be away from home for a long period of
time, disconnect the unit from the wall socket.
NOTES:
÷
If you use an other power cord than provided, we cannot
assume the liabilities in what may occur as a result of it.
÷
(The provided power cord has a current capacity of 7 A.)
#
AC OUTLETS
[SWITCHED TOTAL 100 W MAX]
Power supplied through these outlets is turned on and off by the
amplifier’s POWER ON/OFF switch. Total electrical power con-
sumption of connected equipment should not exceed 100 W.
[UNSWITCHED 100 W MAX]
Power flows continually to this outlet, regardless of whether the
amplifier is switched ON or OFF. Electrical power consumption of
the connected equipment should not exceed 100 W.
NOTES:
Do not connect appliances with high power consumption
such as heaters, irons, or television sets to the AC OUT-
LETS in order to avoid overheating or fire risk. This can
cause the amplifier to malfunction.
The equipment should be disconnected by removing the
mains plug from the wall socket when not in regular use,
e.g. when on vacation.
TAPE 2 MONITOR
SIGNAL
GND
L
R
PHONO
I
N
TUNER
IN
CD
IN
LINE/
SURROUND
BACK
IN
TAPE 1/CD-R/MD
REC
PLAY
REC
PLAY
OUT
IN
OUT
IN
L
R
SPEAKERS
AC INLET
CONTROL
OUT
R
L
R
A
B
L
ª
·
·
ª
1
0
-
!
~
=
@
AC 120 V 60 Hz
SWITCHED
TOTAL
100W MAX
UNSWITCHED
100W MAX
AC
OUTLETS
CAUTION:
DO NOT CONNECT
TV SET OR MONITOR.
ATTENTION:
NE RELIEZ PAS
AL'APPAREIL
DE TELEVISION
OU AU MONITEUR.
2
3
4
6
5
7
8
9
#
PANEL FACILITIES
1
GND (Turntable ground) terminal
2
PHONO terminals
3
TUNER terminals
4
CD terminals
5
LINE/SURROUND BACK terminals
6
TAPE 1/CD-R/MD REC (OUT) terminals
7
TAPE 1/CD-R/MD PLAY (IN) terminals
8
TAPE 2 MONITOR REC (OUT) terminals
9
TAPE 2 MONITOR PLAY (IN) terminals
0
SPEAKERS B terminals (Right channel)
-
SPEAKERS B terminals (Left channel)
=
SPEAKERS A terminals (Right channel)
~
SPEAKERS A terminals (Left channel)
!
CONTROL OUT jack (see page 6)
This jack is for output of control signals when operating other
components bearing the
Î
mark with the attached remote
control unit.