Pioneer BDP-23FD Owner's Manual - Page 43

2 Select and set the method for switching the speaker to be adjusted. Use / to select, then press ENTER. Off - The player's IP address must be set manually. Use the number buttons (0 to 9) to input the IP 06 address, subnet mask and default gateway. • Auto - Switch the speaker to be adjusted automatically. • Manual - Switch the speaker to be adjusted manually. 3 Adjust the output level. Use / to select, / to adjust. • Auto Set DNS Server Address On - The DNS server's IP address is obtained automatically. Off - The DNS server's IP address must be set manually. Use the number buttons (0 to 9) to input the DNS server's IP address stipulated by your Internet service provider. Channel Level BD PLAYER L 0.0 dB C 0.0 dB R 0.0 dB SR 0.0 dB SBR 0.0 dB SBL 0.0 dB SL 0.0 dB SW 0.0 dB Note • When Auto Set IP Address is set to Off, Auto Set DNS Server Address is also set to Off. • For information on DHCP server function, refer to the network device's operating instructions. • You may need to contact your Internet service provider or network administrator when inputting the IP address manually. Note • You can also adjust while listening to the sound being played (page 35). • The volume of the test tones output from the subwoofer may seem lower than the tones output from the other channels. Adjust the subwoofer based on the sound during playback (page 35).  Setting the proxy server Only set the proxy server if so instructed by your Internet service provider. 1 Select and set Network  Proxy Server  Next Screen. Use / to select, then press ENTER. • When Auto is selected, the speaker cannot be selected with /. In this case, test tones are not output from the subwoofer.  Setting the IP address 1 Select and set Network  IP Address  Next Screen. Use / to select, then press ENTER. 2 Select and set Use or Not use at Proxy Server. Use / to change, then press . Network BD PLAYER Proxy Server Proxy Server Server Select Method Server Name Port Number Use  Server Name 2 Set IP address. Use to set the IP address of the player or DNS server, then press ENTER. Network BD PLAYER • Use - Select this when using a proxy server. • Not use - Select this when not using a proxy server. IP Address Auto Set IP Address Off  IP Address Subnet Mask Default Gateway Auto Set DNS Server Address Off DNS Server (Primary) DNS Server (Secondary) If you have selected Use, proceed to step 3. 3 Select and set Server Select Method. Use / to change, then press . • IP Address - Input the IP address. • Server Name - Input the server name. • Auto Set IP Address 4 Input IP Address or Server Name. Use the number buttons (0 to 9) to input the number if you select IP address by step 3. Use / to move the cursor. On - The player's IP address is obtained Use the number buttons (0 to 9) to input characters if you automatically. Select this when using a broadband select Server Name by step 3. router or broadband modem that has a DHCP The characters that can be input for the server name are (Dynamic Host Configuration Protocol) server listed on the table below. Pressing a button repeatedly function. This player's IP address will automatically cycles through the characters shown. be allocated from the DHCP server. 43 En