Pioneer CT-W208R Operating Instructions - Page 11

PLAYBACK SINGLE PLAYBACK (Either DECK I or DECK II) 23 B STEREO DOUBLE CASSETTE DECK Î DECK I + AUTO REVERSE Auto Tape Selector MUSIC SEARCH SYSTEM / PLAYBACK MS - COPY I 3 II NORMAL HIGH DOLBY NR B OFF C DECK II REV MODE RELAY/SKIP DECK @I POWER - OFF _ ON HIGH SPEED COPY SYSYEM MIN DECK @II + MS - REC LEVEL MAX DECK @II AUTO REVERSE Auto Tape Selector MUSIC SEARCH SYSTEM / PLAYBACK DOLBY B-C NR 1 5 (5) (1) 1. Load a prerecorded tape in DECK I or II. 2. Set the DOLBY NR switch. ÷ Always set the switch to the same position that was used for recording. 3. Set the REV MODE switch (see page 9). 4. Set the stereo amplifier for tape playback. 5. Press the playback (3 or 2) button of either DECK I or II. To stop playback temporarily(DECK II only) Press the pause (8) button. ÷ To resume playback, either press the pause (8) button again, or press the playback (3 or 2) button. To stop playback Press the stop (7) button. NOTE: When the play button (forward) is pressed during fast forward, the unit will play back in the reverse direction, and then play back in the forward direction. (vice versa for reverse) Example: When 3 is pressed during fast forward: Fast forward = stop = Reverse play (0.5 seconds) = stop = Forward play BLANK SKIP REV MODE O p π RELAY/SKIP This function allows you to skip unrecorded portions of the tape during playback. Set the REV MODE switch to . NOTES: ÷ When the REV MODE switch is set to the position, the relay mode will be selected. ÷ When this mode is selected, if the tape deck encoun- ters an unrecorded portion of tape more than 15 seconds in length, it will fast forward the tape until it encounters another recorded portion, and resume playback from that point. 11