Pioneer DEH-1000 Operation Manual - Page 6

Section 02 Operating this unit 4 TP indicator Shows when a TP station is tuned in. 5 TA indicator Shows when TA (traffic announcement standby) function is on. 6 RPT indicator Shows when repeat play is turned on. 7 LOUD indicator Appears in the display when loudness is turned on. 8 Stereo (5) indicator Shows when the selected frequency is being broadcast in stereo. 9 LOC indicator Shows when local seek tuning is on. Basic Operations Turning the unit on and selecting a source You can select a source you want to listen to. To switch to the built-in CD player, load a disc in the unit (refer to page 9). % Press SOURCE to select a source. Press SOURCE repeatedly to switch between the following sources: Tuner-Built-in CD player-AUX Notes ! In the following cases, the sound source will not change: - When there is no disc in the unit. - When AUX (auxiliary input) is set to off (refer to page 11). ! AUX is set to on by default. Turn off the AUX when not in use (refer to Switching the auxiliary setting on page 11). ! When this unit's blue/white lead is connected to the vehicle's auto-antenna relay control terminal, the vehicle's antenna extends when this unit's source is turned on. To retract the antenna, turn the source off. Adjusting the volume % Use VOLUME to adjust the sound level. Turning the unit off % Press SOURCE and hold until the unit turns off. Tuner Listening to the radio 1 Press SOURCE to select the tuner. 2 Press BAND to select a band. Press BAND until the desired band (F1, F2 for FM or MW/LW) is displayed. 3 To perform manual tuning, briefly press c or d. 4 To perform seek tuning, press and hold c or d for about one second and release. The tuner will scan the frequencies until a broadcast strong enough for good reception is found. # You can cancel seek tuning by briefly pressing c or d. # If you press and hold c or d you can skip stations. Seek tuning starts as soon as you release the button. 6 En