Pioneer DEH-P6000 Owner's Manual - Page 8
Resetting the microprocessor, About the demo mode, Before You Start - features
View all Pioneer DEH-P6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Section 01 Before You Start Removing the front panel 1 Press and hold OPEN to open the front panel. ! Prior to using this unit for the first time after installation ! If the unit fails to operate properly ! When strange or incorrect messages ap- pear on the display % Press RESET with a pen tip or other pointed instrument. 2 Slide and remove the front panel toward you. Take care not to grip it too tightly or to drop the front panel and protect it from contact with water or other fluids to prevent permanent damage. RESET button 3 Put the front panel into the provided protective case for safe keeping. Attaching the front panel 1 Make sure the inner cover is closed. 2 Replace the front panel by clipping it into place. About the demo mode This unit features two demonstration modes. One is the reverse mode, the other is the feature demo mode. Important The red lead (ACC) of this unit should be connected to a terminal coupled with ignition switch on/off operations. If this is not done, the vehicle battery may be drained. Reverse mode If you do not perform an operation within about 30 seconds, screen indications start to reverse, and then continue reversing every 10 seconds. Pressing BAND when power to this unit is turned off while the ignition switch is set to ACC or ON cancels the reverse mode. Press BAND again to start the reverse mode. Resetting the microprocessor The microprocessor must be reset under the following conditions: 8 En