Pioneer DEH-P6500 Owner's Manual - Page 33
Switching the dimmer setting, Adjusting the brightness, Setting the rear output and, subwoofer - aux
View all Pioneer DEH-P6500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
Initial Settings HHHHHHHHHHHHHH Section 08 English 1 Press FUNCTION to select AUX. Press FUNCTION repeatedly until AUX appears in the display. 2 Press a or b to turn AUX on or off. Pressing a or b will turn AUX on or off and that status will be displayed (e.g., AUX :ON). Switching the dimmer setting To prevent the display from being too bright at night, the display is automatically dimmed when the cars headlights are turned on. You can switch dimmer on or off. 1 Press FUNCTION to select Dimmer. Press FUNCTION repeatedly until Dimmer appears in the display. 2 Press a or b to turn Dimmer on or off. Pressing a or b will turn Dimmer on or off and that status will be displayed (e.g., Dimmer :ON). Adjusting the brightness You can adjust the display brightness. Initially this mode is set to 12. 1 Press FUNCTION to select Brightness. Press FUNCTION repeatedly until Brightness appears in the display. 2 Press c or d to adjust the brightness level. Each press of c or d increases or decreases the brightness level. 0 15 is displayed as the level is increased or decreased. Setting the rear output and subwoofer controller This units rear output (rear speaker leads output and RCA rear output) can be used for fullrange speaker (REAR SP :FULL) or subwoofer (REAR SP :S/W) connection. If you switch the rear output setting to the REAR SP :S/W, you can connect a rear speaker lead directly to a subwoofer without using an auxiliary amp. Initially, the unit is set for rear full-range speaker connection (REAR SP :FULL). When rear output are connected to full range speakers (when REAR SP :FULL is selected), you can connect the RCA subwoofer output to a subwoofer. In this case, you can select whether to use the subwoofer controllers (low pass filter, phase) built-in PREOUT :S/W or the auxiliary PREOUT :FULL. 1 Press FUNCTION to select REAR SP. Press FUNCTION repeatedly until REAR SP appears in the display. 2 Press a or b to switch the rear output setting. Pressing a or b will switch between REAR SP :FULL (full-range speaker) and REAR SP :S/W (subwoofer) and that status will be displayed. # When no subwoofer is connected to the rear output, select REAR SP :FULL. # When a subwoofer is connected to the rear output, set for subwoofer REAR SP :S/W. # When the rear output setting is REAR SP :S/W, you cannot change the subwoofer controller. 3 Press c or d to switch the subwoofer output or non fading output (full-range RCA output). Pressing c or d will switch between PREOUT :S/W and PREOUT :FULL and that status will be displayed. En 33