Pioneer DEH-X3600UI Owner's Manual - Page 16

Appendix Additional information Additional information Troubleshooting Symptoms are written in bold and causes in regular, non-indented text. Regular, indented text is used to indicate actions to be taken. Symptoms are written in bold and causes in regular, non-indented text. Regular, indented text is used to indicate actions to be taken. Common The display automatically returns to the ordinary display. You did not perform any operation within about 30 seconds. Perform operation again. The repeat play range changes unexpectedly. Depending on the repeat play range, the selected range may change when another folder or track is being selected or during fast forwarding/reversing. Select the repeat play range again. A subfolder is not played back. Subfolders cannot be played when FLD (folder repeat) is selected. Select another repeat play range. AMP ERROR This unit fails to operate or the speaker connection is incorrect; the protective circuit is activated. Check the speaker connection. If the message fails to disappear even after the engine is switched off/on, contact your dealer or an authorized Pioneer Service Station for assistance. CD player ERROR-07, 11, 12, 17, 30 The disc is dirty. Clean the disc. The disc is scratched. Replace the disc. NO XXXX appears when a display is changed (NO TITLE, for example). There is no embedded text information. Switch the display or play another track/file. The unit is malfunctioning. There is interference. You are using a device, such as a cellular phone, that may cause audible interference. Move electrical devices that may be causing the interference away from the unit. Error messages When you contact your dealer or your nearest Pioneer Service Center, be sure to note the error message. ERROR-07, 10, 11, 12, 15, 17, 30, A0 There is an electrical or mechanical error. Turn the ignition switch OFF and back ON, or switch to a different source, then back to the CD player. ERROR-15 The inserted disc is blank. Replace the disc. ERROR-23 Unsupported CD format. Replace the disc. 16 En FORMAT READ Sometimes there is a delay between the start of playback and when you start to hear any sound. Wait until the message disappears and you hear sound. NO AUDIO The inserted disc does not contain any playable files. Replace the disc. SKIPPED The inserted disc contains DRM protected files. The protected files are skipped. PROTECT All the files on the inserted disc are embedded with DRM. Replace the disc. PROTECT All the files on the connected USB storage device are embedded with DRM. Replace the USB storage device. N/A USB The connected USB device is not supported by this unit. ! Connect a USB Mass Storage Class compliant device. ! Disconnect your device and replace it with a compatible USB storage device. CHECK USB The USB connector or USB cable has shortcircuited. Check that the USB connector or USB cable is not caught in something or damaged. USB storage device/iPod FORMAT READ Sometimes there is a delay between the start of playback and when you start to hear any sound. Wait until the message disappears and you hear sound. NO AUDIO There are no songs. Transfer the audio files to the USB storage device and connect. The connected USB storage device has security enabled. Follow the USB storage device instructions to disable the security. SKIPPED The connected USB storage device contains DRM protected files. The protected files are skipped. CHECK USB The connected USB storage device consumes more than maximum allowable current. Disconnect the USB storage device and do not use it. Turn the ignition switch to OFF, then to ACC or ON and then connect only compliant USB storage devices. CHECK USB The iPod operates correctly but does not charge. Make sure the connection cable for the iPod has not shorted out (e.g., not caught in metal objects). After checking, turn the ignition switch OFF and back ON, or disconnect the iPod and reconnect. ERROR-19 Communication failed. Perform one of the following operations. -Turn the ignition switch OFF and back ON. -Disconnect the USB storage device. -Change to a different source. Then, return to the USB source.