Pioneer DEH-X6800BT Owner's Manual - Page 21

2 Secure the mounting sleeve by using a screwdriver to bend the metal tabs (90°) into place. Dashboard Mounting sleeve • Make sure that the unit is installed securely in place. An unstable installation may cause skipping or other malfunctions. When not using the supplied mounting sleeve 1 Determine the appropriate position where the holes on the bracket and the side of the unit match. 2 Tighten two screws on each side. Trim ring Notched tab • Releasing the front panel allows easier access to the trim ring. • When reattaching the trim ring, point the side with the notched tab down. 2 Insert the supplied extraction keys into both sides of the unit until they click into place. 3 Pull the unit out of the dashboard. To secure the front panel The front panel can be secured with the supplied screw. Screw Screw Mounting bracket Dashboard or console • Use either truss (5 mm × 9 mm) or flush surface (5 mm × 9 mm) screws, depending on the bracket screw holes. Removing the unit (installed with the supplied mounting sleeve) 1 Remove the trim ring. Installing the microphone (Only for DEH-X6800BT/X6810BT/X4800BT/ X4810BT) The microphone should be placed directly in front of the driver at a suitable distance to pick up their voice clearly. CAUTION It is extremely dangerous to allow the microphone lead to become wound around the steering column or shift lever. Be sure to install the microphone in such a way that it will not obstruct driving. It is recommended to use the clamps (sold separately) to arrange the lead. To install on the sun visor 1 Fit the microphone lead into the groove. Microphone lead Groove Microphone Microphone clip Microphone base 2 Install the microphone on the rear side of the steering column. 2 Install the microphone clip on the sun visor. Lowering the sun visor reduces the voice recognition rate. Double-sided tape Microphone clip To install on the steering column 1 Slide the microphone base to detach it from the microphone clip. En 21 English