Pioneer DJM-750 Owner's Manual - Page 4
Connections, Rear panel
View all Pioneer DJM-750 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
Connections Be sure to turn off the power and unplug the power cord from the power outlet whenever making or changing connections. Refer to the operating instructions for the component to be connected. Connect the power cord after all the connections between devices have been completed. Be sure to use the included power cord. Rear panel 1 23 456 46 45 3 4 For Europe For North America OFF POWER ON RETURN R L (MONO) CH 4 PHONO CD/ LINE L CH 3 LINE CD/ LINE L SIGNAL GND CH 2 LINE CD/ LINE L CH 1 PHONO CD/ LINE L SIGNAL GND SEND R L (MONO) R MASTER1 R R R MASTER2 REC OUT BOOTH LL L R L R DIGITAL MASTER OUT CONTROL CH3 CH2 AC IN R R 1 GND 2 HOT 3 COLD f e d c b a 9 8 7 1 POWER button (page 12) Turns this unit's power on and off. 2 RETURN terminals (page 5) Connect to the output terminal of an external effector. When the [L (MONO)] channel only is connected, the [L (MONO)] channel input is simultaneously input to the [R] channel. 3 PHONO terminals (page 5) Connect to a phono level (MM cartridge) output device. Do not input line level signals. To connect a device to the [PHONO] terminals, remove the shortcircuit pin plug inserted in the terminals. Insert this short-circuit pin plug into the [PHONO] terminals when nothing is connected to them to cut external noise. 4 CD/LINE terminals (page 5) Connect to a DJ player or a line level output component. 5 SIGNAL GND terminal (page 5) Connects an analog player's ground wire here. This helps reduce noise when the analog player is connected. 6 LINE terminals (page 5) Connect to a cassette deck or a line level output component. 7 Kensington security slot 8 CONTROL terminal (page 5) This is a Ø 3.5 mm mini phone jack type DJ player control terminal. If you connect a Pioneer DJ player using a control cable (supplied with a DJ player), you can start playback of control other operations of the DJ player with the fader of this unit. 9 DIGITAL MASTER OUT terminal (page 5) Outputs the master channel audio signals. a BOOTH terminals (page 5) These are output terminals for a booth monitor. b REC OUT terminals (page 5) These are output terminals for recording. c MASTER2 terminals (page 5) Connect to a power amplifier, etc. d MASTER1 terminals (page 5) Connect to a power amplifier, etc. Be sure to use these as balanced outputs. Be careful not to accidentally insert the power cord of another unit. e SEND terminals (page 5) Connect to the input terminal of an external effector. When the [L (MONO)] channel only is connected, a monaural audio signal is output. f AC IN Connects to a power outlet using the included power cord. Wait until all connections between the equipment are completed before connecting the power cord. Be sure to use the included power cord. WARNING The short-circuit pin plugs out of the reach of children and infants. If accidentally swallowed, contact a doctor immediately. 4 En