Pioneer F900BT Owner's Manual - Page 12
ducts that connect to the navigation sys - problems
UPC - 012562890265
View all Pioneer F900BT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Chapter 01 Introduction The microprocessor must be reset under the following conditions: ! Prior to using this product for the first time after installation. ! If the product fails to operate properly. ! If there appear to be problems with the op- eration of the system. ! When changing the combination of the equipment. ! When adding/removing additional pro- ducts that connect to the navigation system. ! If your vehicle position shown on the map with a significant positioning error. 1 Turn the ignition switch OFF. 2 Press RESET button with a pen tip or other pointed instrument. RESET button p If you have connected other equipment to this navigation system with IP-BUS, be sure to reset that equipment too. 12 En
The microprocessor must be reset under the
following conditions:
!
Prior to using this product for the first time
after installation.
!
If the product fails to operate properly.
!
If there appear to be problems with the op-
eration of the system.
!
When changing the combination of the
equipment.
!
When adding/removing additional pro-
ducts that connect to the navigation sys-
tem.
!
If your vehicle position shown on the map
with a significant positioning error.
1
Turn the ignition switch OFF.
2
Press RESET button with a pen tip or
other pointed instrument.
RESET
button
p
If you have connected other equipment to
this navigation system with IP-BUS, be sure
to reset that equipment too.
Introduction
En
12
Chapter
01