Pioneer GM-D8601 Owner's Manual - Page 10

Section 03 Connecting the units 1 Route battery wire from engine compartment to the vehicle interior. ! When drilling a cable pass-hole into the vehicle body and routing a battery wire thorough it, take care not to short-circuit the wire damaging it by the cut edges or burrs of the hole. After completing all other amplifier connections, finally connect the battery wire terminal of the amplifier to the positive (+) battery terminal. 2 1 3 1 Positive (+) terminal 2 Battery wire (sold separately) The maximum length of the wire between the fuse and the positive + terminal of the battery is 30 cm (12 in.). 3 Fuse 100 A (GM-D8601) / 150 A (GM-D9601) (sold separately) Each amplifier must be separately fused at 100 A (GM-D8601) / 150 A (GM-D9601). 2 Use wire cutters or a utility knife to strip the end of the battery wire, ground wire and system remote control wire to expose about 10 mm (3/8 in.) of the end of each of the wires, and then twist the exposed ends of the wires. Twist 10 mm (3/8 in.) 3 Connect the wires to the terminal. Fix the wires securely with the terminal screws. 6 4 7 2 1 3 5 1 Battery wire 2 Power terminal 3 Ground wire 4 GND terminal 5 System remote control wire 6 System remote control terminal 7 Terminal screws Connecting the speaker output terminals 1 Use wire cutters or a utility knife to strip the end of the speaker wires to expose about 10 mm (3/8 in.) of wire and then twist the wire. Twist 10 mm (3/8 in.) 2 Connect the speaker wires to the speaker output terminals. Fix the wires securely with the terminal screws. 1 3 2 1 Terminal screws 2 Speaker wires 3 Speaker output terminals 10 En