Pioneer GM-X822 Service Manual - Page 25

GM-X822,X722 25 Connecting the Unit Connecting the PowerTerminal • Always use the special red battery and ground wire [RD-223], which is sold separately. Connect the battery wire directly to the car battery positive terminal (+) and the ground wire to the car body. 1. Pass the battery wire from the engine compartment to the interior of the vehicle. • After making all other connections to the amplifier, connect the battery wire terminal of the amplifier to the positive (+) terminal of the battery. Engine Fuse (30A) compart- Interior of ment the vehicle 4. Connect the wires to the terminal. • Fix the wires securely with the terminal screws. GND terminal Power terminal System remote control terminal System remote control wire (Blue) Ground wire Battery wire Fuse (30A) Drill a 14-mm Positive terminal hole into the Insert the O-ring rubber vehicle body. grommet into the vehicle body. 2. Twist the battery wire, ground wire and system remote control wire. Twist 3. Attach lugs to wire ends. Lugs not supplied. • Use pliers, etc., to crimp lugs to wires. Lug Lug Battery wire Ground wire Connecting the Speaker Output Terminals 1. Expose the end of the speaker wires by about 10 mm and twist using nippers or a cutter. Twist 10 mm 2. Attach lugs to speaker wire ends. Lugs not supplied. • Use pliers, etc., to crimp lugs to wires. Lug Speaker wire 3. Connect the speaker wires to the speaker output terminals. • Fix the speaker wires securely with the terminal screws. Terminal screw Speaker output terminal Speaker wire