Pioneer GM5400T Owner's Manual - Page 8

Section 03 Connecting the units ! Install and route the separately sold battery wire as far as possible from the speaker wires. Install and route the separately sold battery wire, ground wire, speaker wires and the amplifier as far away as possible from the antenna, antenna cable and tuner. About bridged mode to 8 W for stereo connection, or 4 W to 8 W for monaural and other bridge connection. Subwoofer Speaker channel Two-channel output One-channel output Power Nominal input: Min. 135 W Nominal input: Min. 420 W Other than subwoofer Speaker channel Two-channel output One-channel output Power MAX input: Min. 250 W MAX input: Min. 760 W Speaker impedance is max. 4 W, please carefully check. Improper connection to the amplifier may result in malfunction or personal injury due to burns from overheating. For bridged mode for a two-channel amplifier, with a 4 W load, either wire two 8 W speakers in parallel, Left + and Right * (Diagram A) or use a single 4 W speaker. For other amplifiers, please follow the speaker output connection diagram for bridging shown on rear: two 8 W speakers in parallel for a 4 W load or a single 4 W speaker per channel. For any further enquiries, contact your local authorized Pioneer dealer or customer service. Connecting the speakers The speaker output mode can be two-channel (stereo) or one-channel (mono). Connect the speaker leads to suit the mode according to the figures shown below. Two-channel output (Stereo) About suitable specification of speaker Ensure speakers conform to the following standards, otherwise there is a risk of fire, smoke or damage. Speaker impedance is 2 W 1 Speaker (Left) 2 Speaker (Right) 8 En