Pioneer HTZ-77DV Owner's Manual - Page 3
Installation Precautions, LINE VOLTAGE SELECTOR SWITCH, Multi voltage model only
View all Pioneer HTZ-77DV manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
English Installation Precautions • Install components so that there are no obstructions above or either side of them, or by ventilation holes. Also install 5cm away from the wall as shown in the figures. Components feature ventilation holes on the bottom so do not install on thick pile carpets or other surfaces that may block them. • Use a vacuum cleaner periodically to clean the port of the subwoofer to keep it free of dust. Powered subwoofer unit (S-DV77SW) LINE VOLTAGE SELECTOR SWITCH ( Multi voltage model only) The line voltage selector switch is located on the rear panel. Check that it is set properly before plugging the power cord into the outlet. If the voltage is not properly set or if you move to an area where the voltage requirements differ, adjust the selector switch as follows: • Be sure to disconnect the power cord from its outlet before making this adjustment. • Use a medium-sized (flat blade) screwdriver. Insert the tip of the screwdriver into the groove of the selector switch and turn it so that the power voltage marking of your area points to the arrow. 5 cm or more 110 V -120 V 220 V -230 V 240 V 5 cm or more DVD/CD Tuner (XV-DV77) 5 cm or more 6 PLAY/PAUSE STANDBY/ON 15 cm or more 1 R OPEN/CLOSE 0 STOP 7 VOLTAGE SELECTOR CAUTION 220 - 230 V Power source voltage is factory adjusted 220 - 230 volts. If your area is different, change voltage selectors settings. H038 En 5 cm or more POWER-CORD CAUTION Handle the power cord by the plug. Do not pull out the plug by tugging the cord and never touch the power cord when your hands are wet as this could cause a short circuit or electric shock. Do not place the unit, a piece of furniture, etc., on the power cord, or pinch the cord. Never make a knot in the cord or tie it with other cords. The power cords should be routed such that they are not likely to be stepped on. A damaged power cord can cause a fire or give you an electrical shock. Check the power cord once in a while. When you find it damaged, ask your nearest PIONEER authorized service center or your dealer for a replacement. 3 En