Pioneer PDP-S51 Operating Instructions - Page 3

English MOUNTING THE SPEAKERS TO YOUR PLASMA DISPLAY NOTE: The diagram depicts the mounting of the right speaker. The left speaker mounts in the same way. 1. 1 Attach the speakers to the speakers mounting bracket (top and bottom) with the speakers mounting screws (M4 × 10 mm). 2 Remove the seals from the cushions and then attach the cushions to the sides of the speakers in the locations indicated in the diagram below. Speaker Mounting Bracket (For RIGHT-TOP) Speakers Mounting Screw (M4 × 10 mm) Speakers Mounting Screw (M4 × 10 mm) English 3. Hang the speaker mounting bracket on the screw you installed at the top by passing the wide part over it and lowering into the slot; screw in the lower screw temporarily. After passing the wide part of the hole of the speaker mounting bracket (top) over the screw, lower the speaker onto it. After passing the wide part of the hole over the screw, lower the speaker. Speakers Mounting Screw (M5 × 10 mm) Speaker Mounting Bracket (For RIGHTBOTTOM) Cushion Speaker R Cushion Speaker L 2. Loosely attach the speakers mounting screws (M5 × 10 mm) to the plasma display (one location on the left and one on the right). Do not tighten it all the way yet. Leave it loose, with about 5 mm left to tighten. Top, Back of Display Speakers Mounting Screw (M5 × 10 mm) 5 mm Tighten the bottom speaker mounting bracket to the display temporarily (one place bottom). 4. Adjust the position of the speaker and then fix the upper and lower screws firmly. • Adjust the positions of the speakers and the Plasma Display so their top surfaces are the same height. • Adjust the positions of the speakers and the Plasma Display so their side surfaces are parallel. 5. Ti ghten the two screws, at the top and bottom for each speaker (total of four screws), thus fixing the speakers to the display. Speakers Mounting Screw (M5 × 10 mm) Leave a space of about 5 mm Speakers Mounting Screw (M5 × 10 mm) 3