Pioneer PDP-S51 Operating Instructions - Page 4

English CONNECTION TO A PLASMA DISPLAY Connecting your Speaker Cables (to the speaker) Gray line Red Black White Push the lever, insert the end of the speaker cable into the hole, and release the lever. Pay attention to the polarity of the speaker terminals when making connections. (The gray line represents the red terminal) Connecting your Speaker Cables (to the display) Connect the cables correctly with respect to the polarity of the Plasma Display and the speaker terminals, that is, ª cable to ª terminals and · cable to · terminals. To do so, connect the cable with the gray line to the ª terminals and the white cable to the · terminals. Gray line White Gray line Red Black Red NOTE: • Press the lever and insert the end of the cable. • When you release the lever, it clamps onto the speaker cable. Caution • Be sure to turn the connected devices off and remove the power cord from the wall outlet beforehand when changing the connection or installation method. • If you insert the speaker cable too far so that the insulation is touching the speaker terminal, you may not get any sound. Please insert it with showing the copper wire. • Check if the end of the speaker cables are securely connected to the terminals by slightly tugging on the cable after making connections. Loose connections may result in sound dropouts or noise. • If there is a short in the and cables caused by an exposed lead wire, excessive load may be applied to the Plasma Display, resulting in interrupted operation or malfunction. • Incorrect connections of the speaker cable to the right or left of the Plasma Display terminals with respect to the polarity may result in insufficient stereo sound effects, delivering poor bass sounds or unstable sound image. • Bundle the code without pulling the cord. 4