Pioneer PRS-D3000SPL Owners Manual - Page 8
Connecting the Power Terminal
View all Pioneer PRS-D3000SPL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Connecting the Unit Connecting the Power Terminal • Always use the recommended battery and ground wire, which is sold separately. Connect the battery wire directly to the car battery positive terminal (+) and the ground wire to the car body. • Recommended wires size (AWG: American Wire Gauge) is as follows. The battery wire, the ground wire and the optional direct ground wire must be same size. Battery Wire and Ground Wire Size Wire Length less than 1.2 m 1.2-2.1 m 2.1-3.0 m Wire Size 6 AWG 6 AWG 6 AWG 3.0-3.9 m 3.9-4.8 m 4.8-5.7 m 5.7-6.7 m 6 AWG 4 AWG 4 AWG 4 AWG 1. Pass the battery wire from the engine compartment to the interior of the vehicle. • After making all other connections to the amplifier, connect the battery wire terminal of the amplifier to the positive (+) terminal of the battery. The maximum length of the wire between the fuse and the positive (+) terminal of the battery is 45 cm. Engine Interior of compartment the vehicle Positive (+) terminal Fuse 100 A Each amplifier must be SEPARATELY fused at 100 A. Drill a 14 mm hole into the vehicle body. 2. Expose the end of the battery wire and ground wire using nippers or a cutter by about 15-20 mm and twist. Twist 15-20 mm 3. Connect the wires to the terminal. • Before connecting the wires to the terminals, remove the endcap. After connecting the wires to the terminals, attach the endcap. • Fix the wires securely with the terminal screws. System remote control terminal Endcap GND terminal System remote control wire Ground wire Terminal screw Power terminal Battery wire WARNING Failure to securely fasten the battery wire to the terminal using the terminal screws could cause the terminal area to overheat and could result in damage and injury including minor burns. Insert the O-ring rubber grommet into the vehicle body. 7