Pioneer PRV-9200 Operating Instructions - Page 27

Getting started 04 Use the / (cursor up/down) buttons to select Compatible, Not Compatible, or Don't Know, then press ENTER. • Note that progressive scan video is only output through the component video outputs (see page 16). 9 Is this recorder connected to an AV amp/receiver for digital audio? Initial Setup Basic Tuner Video In/Out Audio In Audio Out Language Recording Playback Clock SAeVt Amp Digital Connect Input Line System On Screen Display Front Panel Display Connected Remote Control SetNot Connected Setup Mavigator Use the / (cursor up/down) buttons to select Connected, or Not Connected, then press ENTER. • If you select Not Connected, that completes the setup. Press ENTER to exit the Setup Navigator, or select Go Back if you want to start again. 10 Select the digital audio formats your AV amp/ receiver is compatible with. Initial Setup Basic Tuner Video In/Out Audio In Audio Out Language Recording Playback Clock SAeVt Amp Compatibility Input Line System On Screen Display Front Panel Display Dolby Digital Remote Control Set Dolby Digital, DTS Setup Mavigator PCM only 12 That's it! Press ENTER to finish setting up, or select 'Go Back' if you want to start again. Initial Setup Basic Tuner Video In/Out Audio In Audio Out Language Recording Playback Clock Set Input LineSeSytustpemis complete! On ScreeEnnDjoisypluaysing your DVD recorder! Front Panel Display Remote Control Set Finish Setup Setup Mavigator Go Back Other settings you can make After setting up using the Setup Navigator, you should be ready to start enjoying your DVD recorder. It's possible, however, that you may want to make a couple of additional settings, depending on how the recorder is set up for TV broadcasts. • Manual channel setting - This setting lets you skip channels where there is no station, as well as manually tune to stations. See Manual CH Setting on page 97. • VCR Plus+ channel setting - This setting lets you assign guide channels to ensure that the VCR Plus+ programming system works correctly. See VCR Plus+ CH Setting on page 97. That completes basic setup using the Setup Navigator. • Setting up the remote to control your TV - You can set up the supplied remote control to control many brands of TV. See Setting up the remote to control your TV on page 108. Use the / (cursor up/down) buttons to select Dolby Digital, Dolby Digital, DTS or PCM only, then press ENTER. • Check the operating instructions that came with your AV amp/receiver if you're not sure what it's compatible with. 11 Is your AV amp/receiver compatible with 96 kHz digital audio? Selecting the hard disk or DVD for playback and recording The HDD and DVD buttons (remote control and front panel) are used to select the hard disk (HDD) or DVD for playback and recording. The indicator in the front panel display shows which is currently selected. Initial Setup Basic Tuner Video In/Out Audio In Audio Out Language Recording Playback Clock S9e6tkHz PCM Compatible Input Line System On Screen Display Front Panel Display Compatible Remote Control Set Not Compatible Setup Mavigator Don't Know Use the / (cursor up/down) buttons to select Compatible, Not Compatible, or Don't Know, then press ENTER. • Check the operating instructions that came with your AV amp/receiver if you're not sure. HDD DVD 27 En