Pioneer PRV-9200 Operating Instructions - Page 54

06 Recording Recording from an external component VR mode Video mode HDD You can record from an external component, such as a camcorder or VCR, connected to one of the recorder's external inputs. 3 Set up the recorder. • Use REC MODE to set the recording quality. See Setting the picture quality/recording time on page 46 for detailed information. • Press HDD to record to the hard disk drive, or DVD to record to a DVD. 4 Press ì REC when you're ready to start recording. • The recorder will only start recording from the DV IN/ OUT jack if there is a valid signal. Recording will also pause if the signal is interrupted during recording. HDD DVD INPUT SELECT Note • If your source is copy-protected using CopyGuard, you will not be able to record it. See Restrictions on video recording on page 45 for more details. CLEAR Automatic recording from a satellite tuner ENTER HDD REC REC MODE ì 1 Make sure that the component you want to record from is connected properly to the DVD recorder. See Chapter 2 (Connecting up) for connection options. If you have a satellite tuner or some other kind of set top box connected to the L1 input, you can have the recorder start and stop recording automatically with the timer settings of the connected component. (If the other component doesn't have a built-in timer, you'll need to use it with an external timer unit.) After setting up for Auto Start Recording, this recorder starts recording when it detects a signal from the other component. When the signal ceases, the recorder stops recording. If you want to use this recorder with the timer features of your satellite tuner, see Additional information for cable/ satellite/STB (set-top box) users on page 114. 2 Press INPUT SELECT repeatedly to select one of the external inputs to record from. There are three analog inputs and a DV digital input. The current input is shown on-screen and in the front panel display: • L1 - Input 1/Auto Start Rec • L2 - Input 2 (front panel) • L3 - Input 3 • DV - DV input/output (front panel) Check that the Audio In settings for External Audio, Dual Mono Recording and DV Input are as you want them (see NTSC on PAL TV on page 99). • If the aspect ratio is distorted (squashed or stretched), adjust on the source component or your TV before recording. Important • It takes a little while for this recorder to switch on and start recording after detecting a signal. Please bear this in mind when setting the timer. • If Auto Start Recording is set, it will not start if another timer recording is in progress. • Timer recordings take precedence over Auto Start Recording. Auto Start Recording will stop if a timer recording is due to start. After the timer recording has finished, Auto Start Recording will resume. 1 Set the timer for the satellite receiver (or other component), then switch it into standby (if necessary). Check the manual that came with the receiver if you're not sure how to do this. 54 En