Pioneer VSX-09TX Service Manual - Page 84

VSX-D906S, VSX-07TX, VSX-09TX SPECIFICATIONS Amplifier Section Continuous average power output of 100 watts* per channel, min., at 6 ohms, from 20 Hz to 20,000 Hz with no more than 0.09 %** total harmonic distortion (front). Continuous Power Output Front 100 W + 100 W (1 kHz, 0.8 %, 6 0) Center 100 W (1 kHz, 0.8 %, 6 LI) Surround 100 W + 100 W (1 kHz, 0.8 %, 6 O) Input (Sensitivity/Impedance) PHONO MM 3.8 mV/47 kO LD/SAT, CD, VCR 1, VCR 2, TAPE 1, TAPE 2, DVD/TV, VIDEO 275 mV/47 kO Phono Overload Level (T.H.D. 0.1 %, 1kHz) PHONO MM 100 mV Frequency Response PHONO MM 20 Hz to 20,000 Hz + 0.3 dB LD/SAT, CD, VCR 1, VCR 2, TAPE 1, TAPE 2, DVD/TV, VIDEO 5 Hz to 100,000 Hz dB Output (Level/Impedance) VCR 1, VCR 2, TAPE 1 REC, TAPE 2 REC 275 mV/2.2 Tone Control BASS 4- 6 dB (100 Hz) TREBLE ± 6 dB (10 kHz) Signal-to-Noise Ratio (IHF, short circuited, A network) (Direct On) PHONO MM 80 dB LID/SAT, CD, VCR 1, VCR 2, TAPE 1, TAPE 2, DVD/TV, VIDEO 97 dB Signal-to-Noise Ratio [EIA, at 1 W (1kHz)] (Direct On) PHONO MM 80 dB LD/SAT, CD, VCR 1, VCR 2, TAPE 1, TAPE 2, DVD/TV, VIDEO 83 dB * Measured pursuant to the Federal Trade Commission's Trade Regulation rule on Power Output Claims for Amplifiers. *" Measured by Audio Spectrum Analyzer. VIDEO Section Input (Sensitivity/Impedance) LD/SAT, VCR 1, VCR 2, DVD/TV, VIDEO Output (Level/Impedance) VCR 1 REC, VCR 2 REC, MONITOR TV Frequency Response LD/SAT, VCR 1, VCR 2, DVD/TV, VIDEO MONITOR Signal-to-Noise Ratio Cross Talk 1 Vp-p/75 SZ 1 Vp-p/75 O 5 Hz to 7 MHz 1dB 55 dB 55 dB Manufactured under license from Dolby Laboratories Licensing Corporation. "Dolby", "AC-3", "Pro Logic" and the double-D symbol are trademarks of Dolby Laboratories Licensing Corporation. FM Tuner Section Frequency Range 87.5 MHz to 108 MHz Usable Sensitivity Mono: 11.2 dBf, IHF (1.0 pV/75 0) 50 dB Quieting Sensitivity Mono: 16.8 dBf Stereo: 38.6 dBf Signal-to-Noise Ratio Mono: 73 dB (at 85 dBf) Stereo: 70 dB (at 85 dBf) Distortion Stereo: 0.5 % (1kHz) Alternate Channel Selectivity 60 dB (400 kHz) Stereo Separation 40 dB (1 kHz) Frequency Response 30 Hz to 15 kHz (-±- 1) dB Antenna Input 75 0 unbalanced AM Tuner Section Frequency Range 530 kHz to 1,700 kHz (10 kHz step) Sensitivity (IHF, Loop antenna) 350 pV/m Selectivity 25 dB Signal to Noise Ratio 50 dB Antenna Loop antenna Miscellaneous Power Requirements AC 120 V, 60 Hz Power Consumption 400 W In Standby Condition 2.5 W AC Outlet SWITCHED (x2) 100 W (0.8 A) MAX UNSWITCHED (x1) 100 W (0.8 A) MAX Dimensions 420 (W) x 177 (H) x 449 (D) mm 16-9/16 (W) x 6-15/16 (H) x 17-11/16 (D) in Weight (without package) 13.3 kg (29 lb 4 oz) Furnished Parts FM Antenna 1 AM Loop Antenna 1 Dry Cell Batteries (AA/LR6) 2 Remote Control Unit 1 Operating Instructions 1 Sub instruction manual (Remote Control Unit) 1 Sub instruction manual [System Set up] 1 NOTE: Specifications and the design are subject to possible modifications without notice, due to improvements. FM antenna „_ c Remote control unit AM loop antenna Alkaline dry cell batteries (size "AA" IEC LR6) x 2 1 1 3