Pioneer VSX-832 Instruction Manual 21 MB file size - Page 53

> Before Start > Part Names > Install > Initial Setup > Playback Advanced Setup | Supplementary Information | Others Network Standby Bluetooth Wakeup When this feature is turned "On (default value)", you can turn on the power of the unit via the network using an application that can control this unit. 0 When using "Network Standby", power consumption increases even when this unit is on standby, however, the increase in power consumption is kept to a minimum by automatically entering the HYBRID STANDBY mode, where only essential circuits are operating. 0 When the connection to the network is lost, "Network Standby" is disabled to reduce power consumption. Use the power button on the remote controller or main unit to turn the unit on if this happens. This function wakes up the unit on standby by connecting a BLUETOOTH wireless technology enabled device. "On": When this function is to be used "Off (default value)": When this function is not to be used 0 When this setting is turned "On", power consumption increases even when this unit is on standby, however, the increase in power consumption is kept to a minimum by automatically entering the HYBRID STANDBY mode, where only essential circuits are operating. 0 The setting is fixed to "Off" if "Network/Bluetooth" - "Bluetooth" - "Auto Input Change" is set to "Off". 0 Wait for a while if "Network Standby" or "Bluetooth Wakeup" cannot be selected. It will appear when the network feature is started. Miscellaneous ∫ Tuner AM / FM Frequency Step (North American models) Select a frequency step depending on your area of residence. Select "10 kHz / 0.2 MHz (default value)" or "9 kHz / 0.05 MHz". 0 When this setting is changed, all radio presets are deleted. AM Frequency Step (European, Australian and Asian models) Select a frequency step depending on your area of residence. Select "10 kHz" or "9 kHz (default value)". 0 When this setting is changed, all radio presets are deleted. ∫ Remote ID Remote ID Select an ID for the unit's remote controller from "1 (default value)", "2", and "3" to prevent interference between the unit and other Pioneer components that are installed in the same room. After changing the ID on the main unit, change the ID on the remote controller accordingly with the following procedure. While holding down MODE, press the following buttons for about 3 seconds. 0 To change the remote controller ID to "1": : (The remote indicator flashes once.) 0 To change the remote controller ID to "2": /h (The remote indicator flashes twice.) 0 To change the remote controller ID to "3": 9 (The remote indicator flashes three times.) ∫ Firmware Update Update Notice Version Update via NET Update via USB Availability of a firmware update will be notified via network. "Enable (default value)": Notify updates "Disable": Disable notifications The current firmware version will be displayed. Press ENTER to select when you want to update the firmware via network. 0 You will not be able to select this setting if you do not have Internet access or there is nothing to update. Press ENTER to select when you want to update the firmware via USB. 0 You will not be able to select this setting if a USB storage device is not connected or there is nothing to update in the USB storage device. 0 Wait for a while if "Firmware Update" cannot be selected. It will appear when the network En 53