Pioneer VSX-832 Instruction Manual 21 MB file size - Page 59

> Before Start > Part Names > Install > Initial Setup > Playback Advanced Setup | Supplementary Information | Others Wi-Fi Status MAC Address DHCP IP Address Subnet Mask Gateway DNS Server Proxy URL Proxy Port The information for the connected access point is displayed. "SSID": The SSID of the connected access point "Signal": The signal strength of the connected access point "Status": The status of the connected access point This is the MAC address of the AV receiver. This value is specific to the component and cannot be changed. "Enable (default value)": Auto configuration by DHCP "Disable": Manual configuration without DHCP If "Disable" is selected, you must set "IP Address", "Subnet Mask", "Gateway", and "DNS Server" manually. Displays/Sets the IP address. Displays/Sets the subnet mask. Displays/Sets the gateway. Displays/Sets the primary DNS server. Displays/Sets the proxy server URL. Displays/Sets the proxy server port number when you enter "Proxy URL". Friendly Name AirPlay Password Change the device name for this unit which is shown on other devices connected to the network to an easily recognized name. This is set to Pioneer VSX-832 ****** at the time of purchase. (* stand for alphanumeric characters identifying each unit) 1. Press ENTER to display the Edit screen. 2. Select a character or symbol with the cursors and press ENTER. Repeat it to input 31 or less characters. "A/a": Switches between upper and lower cases. (Pressing MODE on the remote controller also toggles between upper and lower cases.) " " " ": Moves the cursor to the arrow direction. " ": Removes a character on the left of the cursor. " ": Enters a space. 0 Pressing CLEAR on the remote controller will remove all the input characters. 3. After inputting, select "OK" with the cursors and press ENTER. The input name will be saved. You can set a password of up to 31 characters so that only registered users can use AirPlay. 1. Press ENTER to display the Edit screen. 2. Select a character or symbol with the cursors and press ENTER. Repeat it to input 31 or less characters. "A/a": Switches between upper and lower cases. (Pressing MODE on the remote controller also toggles between upper and lower cases.) " " " ": Moves the cursor to the arrow direction. " ": Removes a character on the left of the cursor. " ": Enters a space. 0 To select whether to mask the password with "¢" or display it in plain text, press +Fav on the remote control. 0 Pressing CLEAR on the remote controller will remove all the input characters. 3. After inputting, select "OK" with the cursors and press ENTER. The input password will be saved. En 59