Pioneer VSX-D710S Owner's Manual - Page 18

Preparations SUBWOOFER ON/PLUS/OFF setting mode Sets whether the SUBWOOFER is used or not. Also, when used you have the option to use the "PLUS" setting. Press % or fi to select subwoofer ON, PLUS or OFF. MEMO: • The initial setting is "ON". • Setting the front speaker size to "Small" in the SPEAKERS setting mode automatically locks the subwoofer in the "ON" position. • Use the PLUS for extra bass. When you use PLUS you will get the bass sounds from the subwoofer even if the front speakers are set to "Large". • If you select "OFF" in this setting you won't be able to select subwoofer in the surround back speaker setting above. Crossover frequency setting mode Crossover frequency is the point where the receiver divides the high and low sounds (the frequencies) between the speakers. Since most smaller speakers can't handle deep bass tones, this setting allows you to send those sounds to the subwoofer (or speakers set to "Large" if you don't have a subwoofer) instead of the speakers set to "Small" in your system. Choose the point at which you want the frequency routed to the subwoofer (or "Large" speakers). We recommend setting this to 200 Hz if smaller bookshelf-type speakers are used for your "Small" speakers. Press % or fi to specify the crossover frequency for your small speakers (100 Hz, 150 Hz or 200 Hz). 100Hz 150Hz 200Hz 100 Hz Sends bass frequencies below 100 Hz to the subwoofer (or "Large" speakers). 150 Hz Sends bass frequencies below 150 Hz to the subwoofer (or "Large" speakers). 200 Hz Sends bass frequencies below 200 Hz to the subwoofer (or "Large" speakers). LFE attenuator setting mode Dolby Digital and DTS audio sources include ultra-low bass tones. Set the LFE attenuator as needed to prevent the ultra-low bass tones from distorting the sound from the speakers. Press % or fi to set the attenuation level (0 dB, 10 dB or ** dB(∞)). 0 dB 10 dB ∞ (display "**") MEMO: • The initial setting is "0 dB". ** • When ∞ is selected ( appears in the display), LFE is not available. Low cut filter ON/OFF setting mode Turn the low cut filter ON when distorted sound is output through the subwoofer. Press % or fi to select low cut filter ON or OFF. MEMO: • The initial setting is "OFF". • If the SUBWOOFER is set to "OFF" in the SUBWOOFER ON/OFF setting mode, the low cut filter cannot be set. FRONT speakers distance setting mode Sets the distance from the FRONT speakers to the listening position. Press % or fi to set the distance of the FRONT speakers from the main listening position (within a 30 foot range). MEMO: • The initial setting is 10 ft. • One step equals about 1ft. CENTER speaker distance setting mode Sets the distance from the CENTER speakers to the listening position. Press % or fi to set the distance of the CENTER speaker from the main listening position (within a 30 foot range). MEMO: MEMO: • The initial setting is "100 Hz". • The initial setting is 10 ft. * • If all speakers (front, center, and surround) are set to • When "C " is selected in SPEAKERS setting mode, 18 "Large" in SPEAKERS setting mode, crossover frequency cannot be set because there are no "Small" the Center distance cannot be set. • One step equals about 1 ft. En *** speakers ( appears in the display).