Pioneer VSX-D711 Owner's Manual - Page 49
Controlling the rest of your system, Selecting preset codes, directly, Setting the remote to control - error
View all Pioneer VSX-D711 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 49 highlights
Controlling the rest of your system 09 Setting the remote to control other components There are several ways to set your remote to control the other components in your system. The easiest way to do this is to assign the component's manufacturer preset code (listed on pages 56-67) to one of the MULTI CONTROL buttons on the remote control. The buttons can be set to control the following components: Button Controllable Components DVD: TV: VCR: CD: CD-R: TVC: TUN: DVD or LD player TV or Satellite tuner VCR or Digital Video Recorder CD player CD Recorder, Tape deck or MD player TV or Cable TV tuner FM/AM tuner You can do this directly, or by searching through different preset codes until you find the right one. If you can't find a preset code that matches the component you want to control, you can still teach the remote individual commands from another remote control (page 50). You can cancel or exit any of the steps by pressing and holding MUTE for three seconds. Selecting preset codes directly SOURCE RECEIVER DVD RCV TV VCR MULTI CONTROL CD TUN CD-R TVC 1 2 3 TEST TONE 4 CH SELECT 7 INPUT ATT 5 FL DIMMER 6 LEVEL 8 9 +10 EFFECT DISPLAY DISC 0 ENTER DTV INFO ¶ MPX/RETURN D.ACCESS T.EDIT/GUIDE 7 38 BAND 1 CLASS ¡ DTV ON/OFF 4 DTV MENU ¢ TOP MENU AUDIO SUB TITLE ANGLE REMOTE SETUP STANDARD ADV.SURR. STEREO MIDNIGHT/ INPUT SEL. SIGNAL SEL LOUDNESS MUTE RECEIVER CONTROL TUNE ST U SET P ST ENTER TUNE CHANNEL 1 Press and hold REMOTE SETUP for three seconds. The LED lights steadily for two seconds. 2 Press the MULTI CONTROL button for the component you want to control. 3 Use the number buttons to enter the 4 digit preset code (see pages 56-67) The LED blinks for half a second after you input each digit and shows a long, two second blink once you have entered a valid code. If the LED blinks three times it means an invalid code has been input or an error has occurred. XRB3013A.49.67 • If you assign a preset code for the TUNER button, you won't be able to control the built-in tuner of this receiver using the remote. Reset the remote to the built-in tuner by entering the preset code 7008. 4 Repeat steps 1 through 3 for the other components you want to control. 49 En 49 01.12.12, 4:48 PM