Pioneer VSX-D814-S Operating Instructions - Page 12

02 5 minute guide Using the Quick Setup You can use the Quick Setup to get your system up and running with just a few button presses. The receiver automatically makes the necessary settings after you have selected your speaker setup, room size and listening position. If you want to make more specific settings, refer to Choosing your receiver setup on page 44. Use the front panel controls for the steps below. ADVANCED STEREO/ SURROUND DIRECT SIGNAL MIDNIGHT/ SELECT LOUDNESS SPEAKERS SB CH MODE MULTI JOG TONE QUICK SETUP TENING MODE MMER DIGITAL IN VIDEO INPUT S-VIDEO VIDEO L AUDIO R ENTER MULTI JOG MASTER VOLUME DOWN UP * VSX-D814 only If a subwoofer wasn't detected in step 2, you can cycle between the following choices: 2.0ch 3.0ch 7.0ch* 6.0ch 5.0ch 4.0ch * VSX-D814 only VSX-D514 - Cycle between the following choices: 5.1ch 2.0ch 2.1ch 5.0ch 3.0ch 4.1ch 4.0ch 3.1ch • Check the table below to find the speaker setup that corresponds with your system. 1 If the receiver is off, press STANDBY/ON to turn the power on. 2 Press QUICK SETUP. VSX-D714/D814 only - SW DET flashes in the display while the receiver checks your setup for a subwoofer. SW YES or SW NO confirms the subwoofer check, then the display prompts you to select your speaker setup. 3 Use the MULTI JOG dial to choose your speaker setup. VSX-D714/D814 - When a subwoofer was detected in step 2, you can cycle between the following choices: 2.1ch 7.1ch* 6.1ch 3.1ch 5.1ch 4.1ch * VSX-D714/D814 only ** VSX-D814 only 12 En