Pioneer VSX-D814-S Operating Instructions - Page 25

English Italiano Français Deutsch Nederlands Español Connecting up 03 • To hear sound only from the pre-outs, disconnect any speakers that are connected directly to the receiver. • If you're not using a subwoofer, change the front speaker setting (see Speaker setting on page 46) to large. • VSX-D714 only - If you connect to a surround back speaker, make sure the Surround back speaker setting on page 46 is switched on and set to the proper speaker size. • These speaker terminals are hazardous when live. To prevent the risk of electric shock when connecting or disconnecting the speaker cables, disconnect the power cord. Power cord caution Handle the power cord by the plug. Do not pull out the plug by tugging the cord and never touch the power cord when your hands are wet as this could cause a short circuit or an electric shock. Do not place the unit, a piece of furniture, etc., on the power cord, or pinch the cord. Never make a knot in the cord or tie it with other cords. The power cords should be routed such that they are not likely to be stepped on. A damaged power cord can cause a fire or give you an electrical shock. Check the power cord once in a while. When you find it damaged, ask your nearest Pioneer authorized service center or your dealer for a replacement. Operating other Pioneer components VSX-D714/D814 only By connecting a control cord (optional), you can point the remote controls of other Pioneer components at the receiver's remote sensor. The remote control signals are received by the remote sensor of this unit, and sent to the other devices via the CONTROL OUT terminal of the receiver. OUT CONTROL IN Receiver CONTROL IN OUT Remote control unit Other Pioneer products with CONTROL terminals Connect to CONTROL terminal of other compatible Pioneer products 25 En