Pioneer VSX-D912K Owner's Manual - Page 58

10 Controlling the rest of your system 4 Use the number buttons to enter the 4 digit preset code (see page 66) The LCD display shows the code as you enter it. If you make a mistake press to go back one digit. The display shows OK once you have entered a valid code. If it's an invalid code or an error has occurred, ERROR shows in the display. If you get an error message, check the preset code list and try again. If you can't find or properly enter a preset code, you can still teach the remote individual commands from another remote control (see Programming signals from other remote controls on page 59). • If you assign a preset code for the TUN button, you won't be able to control the built-in tuner of this receiver using the remote. Reset the remote to the built-in tuner by entering the preset code 7008. 5 Repeat steps 1 through 4 for other components you want to control. Searching for preset codes Another way of entering preset codes is to use the search feature. The remote transmits batches of 10 codes; when you see the component you want to control respond (by turning on or off), you just scan through the last 10 codes until you find the right one. DVD TV VCR MULTI CONTROL CD TUN CD-R TVC 1 2 3 4 5 6 7 8 9 0 REMOTE SETUP SET P ENTER U 1 Switch on the component you want to control. If the component is some kind of player (CD player, VCR, etc.), start it playing. 2 Press and hold REMOTE SETUP for three seconds. The LCD display shows SETUP. 3 Press the MULTI CONTROL button for the component you want to control. 4 Use and to select SEARCH. The LCD display shows SEARCH. 5 Press and hold REMOTE SETUP for three seconds. A batch of 10 codes is transmitted and the transmit icon blinks during transmission. 58 En