Pioneer VSX-LX105 ELITE 7.2-Channel Network AV Receiver Instruction Manual Eng - Page 106
Crossover, Front, Default Value: Small, Center, Height, Surround, Surround Back Default Value: Small
View all Pioneer VSX-LX105 ELITE 7.2-Channel Network AV Receiver manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 106 highlights
Speaker Crossover Change the settings of crossover frequencies. Front (Default Value: Small) Center (Default Value: Small) Height (Default Value: Small) Surround (Default Value: Small) Surround Back (Default Value: Small) Crossover (Default Value: 80 Hz) Double Bass (Default Value: On) Front: Set according to the speakers to be used. "Small": When not using floor standing front speakers. "Large": When using floor standing front speakers. • If "Configuration" - "Subwoofer" is set to "No", "Front" will be fixed to "Large" and the low pitched range of the other channels will be output from the front speakers. Refer to the instruction manual of your speakers to make the setting. Center, Height, Surround: Set according to the speakers to be used. "Small": When speaker where the speaker diameter is 16 cm or less are to be used. "Large": When speaker where the speaker diameter is larger than 16 cm are to be used. • When "Front" is set to "Small", this is set to "Small". • If an item cannot be selected even though connection is correct, check that the settings in "Configuration" - "Speaker Channels" matches the number of connected channels. Setup Surround Back: Set according to the speakers to be used. "Small": When speaker where the speaker diameter is 16 cm or less are to be used. "Large": When speaker where the speaker diameter is larger than 16 cm are to be used. • When "Surround" is set to "Small", this is set to "Small". • If an item cannot be selected even though connection is correct, check that the settings in "Configuration" - "Speaker Channels" matches the number of connected channels. Crossover: When there are speakers that have been set to "Small", set the Hz under which you would like other speakers to play bass, and also set Hz under which you would like the LFE (low frequency effect) to play the bass. The value from "50 Hz" to "200 Hz" can be set. Double Bass: This can be selected only when "Configuration" - "Subwoofer" is set to "Yes" and "Front" is set to "Large". Boost bass output by feeding bass sounds from the front left and right speakers and the center speaker to the subwoofer. "On": Bass output will be boosted "Off": Bass output will not be boosted • The setting will not automatically be configured even if you performed Full Auto MCACC. 106