Pioneer VSX91TXH Owner's Manual - Page 70
Press MULTI OPE.
View all Pioneer VSX91TXH manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 70 highlights
11 Controlling the rest of your system 6 If necessary, press the input source button for the component whose command you want to input. This is only necessary if the command is for a new component (input source). 7 Select the button for the command you want to input. The following remote control commands can be selected: RECEIVER INPUT SELECT SYSTEM OFF SOURCE Using multi operations You can start multi operations with the receiver switched on, or in standby. AUDIO SUBTITLE HDD DISP CH PHOTO STATUS SIGNAL SEL SBch DVD CH STEREO/ F.S.SURR MULTI OPE THX STANDARD ADV.SURR SHIFT PHASE MCACC S.DIRECT RECEIVER TV CONTROL XM RADIO DVD SIRIUS TV DVR 2 DVR 1 TV CTRL CD-R/TAPE iPod HDMI 2 HDMI 1 CD TUNER ZONE 2 RECEIVER SLEEP S.RETRIEVER SR+ DIMMER DIALOG E ANALOG ATT MIDNIGHT/ LOUDNESS TV VOL INPUT SELECT TV CH VOL ANT REC INFO MUTE MPX REC STOP JUKEBOX AUDIO SUBTITLE HDD DISP CH PHOTO STATUS SIGNAL SEL SBch DVD CH STEREO/ F.S.SURR D.ACCESS +10 AV PARAMETER TOP MENU TUNE ST SETUP ENTER TUNE GUIDE CLASS DISC ENTER CH LEVEL MENU ST T.EDIT RETURN BAND MULTI OPE THX STANDARD ADV.SURR SHIFT PHASE MCACC S.DIRECT RECEIVER • You don't need to program the receiver to switch on or off. This is done automatically. With Pioneer components, you don't need to: • program the power to switch off in a shutdown sequence (except DVD recorders); • program the power to switch on if it's the source component selected in step 3; • program a Pioneer TV or monitor to switch on if the input function (selected in step 2) has video input terminals; These take priority in multi operations (not shutdown). 8 Repeat steps 5-7 to program a sequence of up to five commands. 9 When you're finished, use / to select EDITEXIT from the menu and press ENTER. You will return to the remote control SETUP menu. Select * EXIT * again to exit. 1 Press MULTI OPE. MULTI OP flashes in the display. 2 Press an input source button that has been set up with a multi operation. The receiver switches on (if it was in standby) and the programmed multi operation is performed automatically. Using System off RECEIVER INPUT SELECT SYSTEM OFF SOURCE AUDIO SUBTITLE HDD DISP CH PHOTO STATUS SIGNAL SEL SBch DVD CH STEREO/ F.S.SURR MULTI OPE THX STANDARD ADV.SURR SHIFT PHASE MCACC S.DIRECT XM RADIO DVD SIRIUS TV DVR 2 DVR 1 TV CTRL RECEIVER 1 Press MULTI OPE. MULTI OP flashes in the display. 2 Press SOURCE . The command sequence you programmed will run, then all Pioneer components will switch off1, followed by this receiver. Note 1 In order to avoid accidently switching off a DVD recorder that is currently recording, no DVD recorder power off codes are sent. 70 En