Pioneer XW-NAS3-K Operating Instructions - Page 10

03 iPod playback 1 Attach the Dock adaptor to iPod connector port on the top panel of this unit. • An iPod Dock adaptor is not supplied with this unit. When attaching the Dock adaptor, be sure to orient the front-back directions of the Dock adaptor correctly. To attach, first place the protruding tabs on the front side of the adaptor into the depressions on the iPod connector port and press into position. When attaching the adaptor, be careful not to strike the connectors. 2 Connect your iPod. Connecting your TV To watch iPod images on a television, perform connections using either a composite video cable or component video cable. • When using a component video cable for connections, it is necessary to adjust the unit's video output. See Setting the video output below. • When an iPod is connected to this unit, the iPod's TV output setting is automatically set to ON. While connected, the iPod can be used to switch the TV output setting.1 Caution • Before making or changing the connections, switch off the power and disconnect the power cord from the power outlet. Plugging in should be the final step. TV Component video cable (commercially available) Composite video cable (commercially available) ADAPTER PORT VIDEO 2 MONITOR OUT VIDEO 1 Y PB PR AUDIO IN COMPONENT VIDEO Setting the video output Adjust the video output on this unit in accordance with the method used to connect the television.2 • Default setting: Composite INPUT 1 Switch the unit into standby. 2 Press and hold INPUT on the remote control for three seconds. The iPod indicator will flash two times, and the video output will switch to Component. When step 2 is repeated again, the iPod indicator will flash one time, and the video output will switch to Composite. Note 1 • This function is limited to iPod models providing TV output settings. • When the iPod is disconnected from this unit, the iPod's TV output setting returns to its original state. 2 • Stop the iPod's video playback before adjusting the video output setting. The setting mode is disabled during playback and pause. • During the video output setting process, if no button operation is performed for 3 minutes, the setting will be canceled and power will return to the standby mode. 10 En