Pioneer XW-NAS3-K Operating Instructions - Page 18
Additional information, Resetting the system, About iPod/iPhone, Specifications
View all Pioneer XW-NAS3-K manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
06 Additional information Resetting the system Use this procedure to reset all system settings to the factory default. • When performing reset, first disconnect all components connected to this unit. 1 Switch the unit on. 2 Press and hold VOLUME - on the top panel, and then press and hold STANDBY/ ON for three seconds. Power is set to standby mode. The next time you switch on, all the system settings should be reset. About iPod/iPhone "Made for iPod" and "Made for iPhone" mean that an electronic accessory has been designed to connect specifically to iPod or iPhone, respectively, and has been certified by the developer to meet Apple performance standards. Apple is not responsible for the operation of this device or its compliance with safety and regulatory standards. iPod and iPhone are trademarks of Apple Inc., registered in the U.S. and other countries. Specifications • Amplifier section RMS Power Output: Front Left/Right 15 W + 15 W (1 kHz, 10 %, T.H.D., 8 Ω) Subwoofer . . 30 W (100 Hz, 10 %, T.H.D., 4 Ω) • Speaker section Enclosure . . . Bass-reflex (magnetically shielded) System 2-way system Speakers: Subwoofer 10 cm (4 in.) cone Fullrange 5.2 cm (2 in.) cone Frequency range 50 Hz to 20 kHz • Miscellaneous Power requirements AC 120 V/60 Hz Power consumption 30 W In standby 0.5 W Dimensions 420 mm (W) x 148 mm (H) x 210 mm (D) (16 9/16 in. (W) x 5 7/8 in. (H) x 8 5/16 in. (D)) Weight (without package 4.9 kg (10.8 lb) • Accessories Remote control 1 Remote control holder 1 Lithium battery (CR2025 1 Power cord 1 Cleaning cloth 1 Operating instructions (This document) Note • Specifications and the design are subject to possible modifications without notice, due to improvements. 18 En