Pioneer XW-NAS3-K Operating Instructions - Page 17

Additional information 06 English Deutsch Français Italiano Nederlands Español Chapter 6: Additional information Troubleshooting Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong with this component, check the points below. Sometimes the trouble may lie in another component. Investigate the other components and electrical appliances being used. If the trouble cannot be rectified even after exercising the checks listed below, ask your nearest Pioneer authorized service center or your dealer to carry out repair work. • If the unit does not operate normally due to external effects such as static electricity disconnect the power plug from the outlet and insert again to return to normal operating conditions. Problem Remedy The power does not turn on. • Disconnect the power plug from the outlet, and insert again. • If the power shuts off automatically, take the unit to your nearest Pioneer authorized service center or your dealer for servicing. Power automatically switches to • When input is set to iPod, if no iPod is connected for one hour or more, standby without user action. the unit's power automatically turns OFF. No sound is output when a function is selected. • Make sure the component is connected correctly (refer to Connecting auxiliary components on page 16). Can't operate the remote control. • Replace the battery (refer to page 6). • Operate within 7 m (23 ft.), 30° of the remote sensor on the front panel (refer to page 7). • Remove the obstacle or operate from another position. • Avoid exposing the remote sensor on the front panel to direct light. The Bluetooth wireless • Check that no object that emits electromagnetic waves in the 2.4 GHz technology device cannot be band (microwave oven, wireless LAN device or Bluetooth wireless connected or operated. Sound technology apparatus) is near the unit. If such an object is near the unit, from the Bluetooth wireless set the unit far from it. Or, stop using the object emitting the technology device is not emitted electromagnetic waves. or the sound is interrupted. • Check that the Bluetooth wireless technology device is not too far from the unit and that obstructions are not set between the Bluetooth wireless technology device and the unit. Set the Bluetooth wireless technology device and the unit so that the distance between them is less than about 10 m (32 ft.) and no obstructions exist between them. • Check that the Bluetooth ADAPTER and the ADAPTER PORT of the unit are correctly connected. • The Bluetooth wireless technology device may not be set to the communication mode supporting the Bluetooth wireless technology. Check the setting of the Bluetooth wireless technology device. • Check that pairing is correct. The pairing setting was deleted from this unit or the Bluetooth wireless technology device. Reset the pairing. • Check that the profile is correct. Use a Bluetooth wireless technology device that supports A2DP profile and AVRCP profile. 17 En