Plantronics CS70 User Guide - Page 5

72536-05_CS70_US_12.06.qxd:05-PI-010 6/18/07 12:53 PM Page 8 SETUP-HANDSET LIFTER (Optional) 1 2 1. Plug handset lifter power cord into handset lifter jack on base. Push firmly into base. 2. Position handset lifter under the handset on your phone. Verify that the lifter is located on top of the telephone speaker. If not, you will need to attach the ringer microphone as described on page 22. NOTE: Remove only a tiny piece of the mounting tape backing to temporarily stick the lifter into a test position. Once you have determined the best position for the lifter (see page 15), remove the mounting tape backing to adhere the lifter to your telephone. 3 IntelliStand™ off Set the IntelliStand switch to Intellistand off (-) if you do not want the lifter to pick up when IntelliStand you take the headset off the on charging cradle. Set the Intellistand switch to Intellistand on (= ) if you want the handset to automatically pick up when you take the headset off the charging cradle. 8 CHARGING 1. Slide headset into charging cradle so that microphone boom is on the right. 2. Gently press down on the headset to ensure that headset is in correct position. Amber charge indicator 1 light on base will flash while charging and will change to solid amber when fully charged. • 20 minutes = minimum charge to continue setup • 3 hours = full charge 2 POSITIONING 12" 6" The minimum recommended separation distance is shown above. IMPORTANT: Incorrect positioning can cause noise and interference problems. 9