Plantronics CS70 User Guide - Page 6

Adjusting Fit, Multi-shift Pairing

Page 6 highlights

72536-05_CS70_US_12.06.qxd:05-PI-010 6/18/07 12:53 PM Page 10 ADJUSTING FIT 1 2 3 1. Slide the headset over and behind your ear. 2. Rotate and press gently towards your ear for a snug fit. 3. Rotate microphone until it is pointed towards your chin. MULTI-SHIFT PAIRING 1 2 Enable Disable OR OR 1. To pair another headset to the same base, you must first enable the multi-shift pairing feature. Long press (5 sec.) the speaking volume minor adjust up button on back of base until the power indicator light flashes. 2. Place a charged headset in charging cradle and red indicator light on base will flash for 2 seconds if doing so, press ethitehemrutlhtei-s"+hi"ftopra"ir-i"nglisfeteantuinrge is enabled. Within volume button for 10 seconds of 3 seconds until the headset talk indicator lights to indicate pairing mode, and goes out after successful pairing. Repeat steps 1 and 2 if headset and base do not link when call control button is pressed. NOTE: Only the last paired headset will work with the base. You must NOT be in talk mode (i.e. not on a call) when enabling or disabling this feature. To disable the multi-shift pairing feature, long press (5 sec.) the speaking volume minor adjust down button until the power indicator light flashes. 10 11

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12

11
10
ADJUSTING FIT
MULTI-SHIFT PAIRING
2
1
Enable
Disable
OR
OR
OR
1. Slide the headset over and behind your ear.
2. Rotate and press gently towards your ear for a snug fit.
3. Rotate microphone until it is pointed towards your chin.
2
3
1
1. To pair another headset to the same base, you must first enable the multi-shift
pairing feature. Long press (5 sec.) the speaking volume minor adjust
up
button on
back of base until the power indicator light flashes.
2. Place a charged headset in charging cradle and red indicator light on base will flash
for 2 seconds if the multi-shift pairing feature is enabled. Within 10 seconds of
doing so, press either the "
+
" or "
-
" listening volume button for 3 seconds until the
headset talk indicator lights to indicate pairing mode, and goes out after successful
pairing. Repeat steps 1 and 2 if headset and base do not link when call control
button is pressed.
NOTE: Only the last paired headset will work with the base. You must NOT be in talk mode
(i.e. not on a call) when enabling or disabling this feature.
To disable the multi-shift pairing feature, long press (5 sec.) the speaking volume
minor adjust
down
button until the power indicator light flashes.
72536-05_CS70_US_12.06.qxd:05-PI-010
6/18/07
12:53 PM
Page 10