Poulan 460ZX User Manual - Page 19

Seat Adjustment Lever, Bypass Linkage, Unlocking Transmission

Page 19 highlights

CONTROLS Seat Adjustment Lever The seat can be adjusted lengthways. Release levers are located at the lower front right, or on the right side-depending on model. When making adjustments, sit on the seat. Slide the lever and maneuver seat to appropriate placement and release lever. IMPORTANT INFORMATION Before pushing or towing tractor, transmission must be unlocked and park brake released. The tractor should never be pulled at more than 2 miles per hour (3.2 km/h) or for distances over ¼ mile (.402 km). Trailer the unit for distances over ¼ mile. Bypass Linkage Unlocking Transmission When pushing or pulling the mower, engage the EZT (Integrated Zeroturn Transaxle) bypass linkages. The EZT bypass linkages are located on the rear of the frame, below the rear engine guard. 1. Raise the deck into the highest cutting position. 2. Pull the EZT bypass linkages up and out of the keyhole slots. Release the levers with the head outside the frame and held in the bypass position. 3. To reengage the EZT's to drive, reverse the above procedure. Seat adjustment Bypass linkage, EZT engaged 8050-852 8058-032 Bypass linkage, EZT locked in the bypass position 8058-033 19

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60

CONTROLS
19
Seat Adjustment Lever
The seat can be adjusted lengthways. Release
levers are located at the lower front right, or on the
right side—depending on model. When making
adjustments, sit on the seat. Slide the lever and
maneuver seat to appropriate placement and release
lever.
8050-852
Seat adjustment
Bypass Linkage
Unlocking Transmission
When pushing or pulling the mower, engage the EZT
(Integrated Zeroturn Transaxle) bypass linkages. The
EZT bypass linkages are located on the rear of the
frame, below the rear engine guard.
Raise the deck into the highest cutting
1.
position.
Pull the EZT bypass linkages up and out of
2.
the keyhole slots. Release the levers with the
head outside the frame and held in the bypass
position.
To reengage the EZT’s to drive, reverse the
3.
above procedure.
8058-032
Bypass linkage, EZT engaged
8058-033
Bypass linkage, EZT locked in the bypass position
IMPORTANT INFORMATION
Before pushing or towing tractor, transmission
must be unlocked and park brake released.
The tractor should never be pulled at more
than 2 miles per hour (3.2 km/h) or for
distances over ¼ mile (.402 km). Trailer the
unit for distances over ¼ mile.