Poulan HDF550M User Manual - Page 5
Install, Depth, Stake, Assembly
![]() |
View all Poulan HDF550M manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
ASSEMBLY UNPACK CARTON & INSTALL HANDLE (See Fig. 2) a CAUTION: Be careful of exposed staples when handling or disposing of cartoning material. IMPORTANT: WHEN UNPACKING AND ASSEMBLING TILLER, BE CAREFUL NOT TO STRETCH OR KINK CABLE(S). • Cut cable ties securing handles. • Slowly lift handle assembly up, route cable(s) as shown and align handle holes with handle panel hole and slot. • Loosely assemble hardware as shown. Be sure the shorter (3/4" long) hex bolt is assembled in lower hole of handle. Repeat for opposite side. Tighten all hardware securely. • Cut cable ties securing tiller to skid and remove tiller from skid. • Remove screws securing depth stake to skid and discard the screws. HANDLE PANEL LOCK NUT WASHER TILLER HANDLE / GI \ HEX BOLT 5/16-18X1" FLAT WASHER HEX BOLT 5/16-18X3/4" CABLE(S) TILLER HANDLES HANDLE PANEL BOLTS 2 . 0 INSTALL DEPTH STAKE ASSEMBLY (See Fig. 3) • Loosen nut "A". • Insert stake support between engine bracket halves with stake spring down. • Bolt stake support to engine brackets with bolts, lock washers and nuts. Tighten securely. Tighten nut "A". • Depth stake must move freely. If it does not, loosen support bolt. ENGINE BRACKET HALVES NUT "A" DEPTH STAKE DEPTH STAKE SUPPORT i s o o o o SUPPORT BOLT HEX BOLTS, LOCK WASHERS, AND HEX NUTS FIG. 3 STAKE SPRING HANDLE HEIGHT Handle height may be adjusted to better suit operator. (See "HANDLE HEIGHT" in the Service and Adjustments section of this manual). TILLING WIDTH Tilling width may be adjusted to better handle your tilling conditions (See "TINE ARRANGEMENT" in the Service and Adjustments section of this manual). TINE OPERATION • Check tine operation before first use. (See "TINE OPERATI0N CHECK" in the Service and Adjustments section of this manual). FIG. 2 i 5
![](/manual_guide/products/poulan-hdf550m-user-manual-5e66381/5.png)