Poulan PP175G42 Owner Manual - Page 7

ASSEMBLY TO INSTALL STEERING WHEEL (See Fig. 2) ASSEMBLE EXTENSION SHAFT AND BOOT • Slide extension shaft onto lower steering shaft. • Place tabs of steering boot over tab slots in dash and push down to secure. INSTALL STEERING WHEEL • Position front wheels of the tractor so they are pointing straight forward. • Remove steering wheel adapter from steering wheel and slide adapter onto steering shaft extension. • Position steering wheel so cross bars are horizontal (left to right) and slide inside boot and onto adapter. • Assemble large flat washer, lock washer, hex bolt and tighten securely. • Snap steering wheel insert into center of steering wheel. • Remove protective materials from tractor hood and grill. IMPORTANT: CHECK FOR AND REMOVE ANY STAPLES IN SKID THAT MAY PUNCTURE TIRES WHERE TRACTOR IS TO ROLL OFF SKID. INSERT 5/16 HEX BOLT 5/16 LOCK WASHER LARGE FLAT WASHER STEERING WHEEL TABS LOWER STEERING SHAFT STEERING BOOT ADAPTER EXTENSION SHAFT TAB SLOTS Fig. 2 INSTALL SEAT (See Figs. 3 & 4) • Remove bolt and flat washer securing seat to cardboard packing and set aside for assembly of seat to tractor. Remove the cardboard packing and discard. • Connect the wiring harness to the seat switch though the seatpan hole • Place seat on seat pan so all three (3) bottom pads are positioned over large slotted holes in pan. SEAT SWITCH PAD SLOT SEAT PAN TAPE WIRING HARNESS Fig. 3 • Push down on seat to engage pads in slots and pull seat towards rear of tractor. • Raise seat and tighten bolt securely. • Remove tape and discard. • Lower seat into operating position and sit on seat. Press clutch/brake pedal all the way down. If operating position is not comfortable, adjust seat. TO ADJUST SEAT • Grasp adjustment handle and pull up, slide seat to desired position and release adjustment handle. SLOT PAD FLAT WASHER TAPE SEAT PAN BOLT TAB Fig. 4 ADJUSTMENT HANDLE 7