Poulan PP291EPS30 User Manual - Page 14

Maintenance - dealers

Get Poulan PP291EPS30 PDF manuals and user guides View all Poulan PP291EPS30 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 14 highlights

MAINTENANCE GENERAL RECOMMENDATIONS The warranty on this snow thrower does not cover items that have been subjected to operator abuse or negligence. To receive full value from the warranty, operator must maintain snow thrower as instructed in this manual. Some adjustments will need to be made periodically to properly maintain your snow thrower. All adjustments in the Service and Adjustments section of this manual should be checked at least once each season. • Once a year, you should replace the spark plug and check belts for wear. A new spark plug will help your engine run better and last longer. • Follow the maintenance schedule in this manual. NOTE: Use only Original Equipment Manufacturer (OEM) parts to service this unit. Failure to do so can cause the unit to malfunction and pose a risk of injury to the operator. LUBRICATION CHART SAE 5W-30 Motor Oil See "ENGINE" in Maintenance section General Purpose Grease Pivot points BEFORE EACH USE 1. Check engine oil level. 2. Check for loose fasteners. 3. Check controls to be sure they are functioning properly. LUBRICATION Keep your snow thrower well lubricated (See "LUBRICATION CHART"). Auger grease fittings Engine oil SNOW THROWER BELTS Always observe the safety rules when performing any Check belts for deterioration and wear after every 50 hours maintenance. of operation and replace if necessary. The belts are not TIRES • Maintain proper air pressure in both tires (14-17 P.S.I.). • Keep tires free of gasoline and oil, which can harm rubber. adjustable. Replace belts if they begin to slip from wear. (See "TO REMOVE BELT COVER" in the Service and Adjustments section of this manual). The belts on your snow thrower are of special construction and should be replaced by original equipment manufacturer NOTE: To seal tire punctures and prevent flat tires due (OEM) belts available from your nearest dealer. Using other to slow leaks, tire sealant may be purchased from your than OEM belts can cause personal injury or damage to local parts dealer. Tire sealant also prevents tire dry rot the snow thrower. and corrosion. 14

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
14
SAE 5W-30 Motor Oil
See “ENGINE” in
Maintenance section
General
Purpose
Grease
GENERAL RECOMMENDA TIONS
The warranty on this snow thrower does not cover items
that have been subjected to operator abuse or negligence.
To receive full value from the warranty, operator must
maintain snow thrower as instructed in this manual.
Some
adjustments will need to be made periodically to properly
maintain your snow thrower.
All adjustments in the Service
and Adjustments section of this manual should be checked
at least once each season.
•
Once a year, you should replace the spark plug and
check belts for wear.
A new spark plug will help your
engine run better and last longer.
•
Follow the maintenance schedule in this manual.
NOTE:
Use only Original Equipment Manufacturer (OEM)
parts to service this unit.
Failure to do so can cause the unit
to malfunction and pose a risk of injury to the operator.
BEFORE EACH USE
1.
Check engine oil level.
2.
Check for loose fasteners.
3.
Check controls to be sure they are functioning properly.
LUBRICATION
Keep your snow thrower well lubricated
(See “LUBRICA TION CHART”).
MAINTENANCE
LUBRICATION CHART
Engine
oil
Pivot
points
SNOW THROWER
Always observe the safety rules when performing any
maintenance.
TIRES
•
Maintain proper air pressure in both tires
(14–17 P.S.I.).
•
Keep tires free of gasoline and oil, which can harm rubber.
NOTE:
To seal tire punctures and prevent flat tires due
to slow leaks, tire sealant may be purchased from your
local parts dealer. Tire sealant also prevents tire dry rot
and corrosion.
BELTS
Check belts for deterioration and wear after every 50 hours
of operation and replace if necessary. The belts are not
adjustable. Replace belts if they begin to slip from wear.
(See “TO REMOVE BELT COVER” in the Service and
Adjustments section of this manual).
The belts on your snow thrower are of special construction
and should be replaced by original equipment manufacturer
(OEM) belts available from your nearest dealer. Using other
than OEM belts can cause personal injury or damage to
the snow thrower.
Auger
grease fittings