Poulan PP291EPS30 User Manual - Page 9

MUFFLER GASOLINE FILLER CAP CHOKE CONTROL SAFETY IGNITION KEY ON / OFF SWITCH PRIMER FUEL SHUT-OFF VALVE RECOIL (AUXILIARY) STARTER HANDLE OPERATION ELECTRIC AUGER DISCHARGE CHUTE CONTROL LEVER START CONTROL BUTTON LEVER DRIVE SPEED CONTROL LEVER DEFLECTOR REMOTE CONTROL LEVER POWER CORD PLUG CHUTE DEFLECTOR TRACTION DRIVE CONTROL LEVER DISCHARGE CHUTE CLEAN-OUT TOOL LH TURN TRIGGER LIGHT HANDLE KNOB NOTE: ITEMS ABOVE ARE SHOWN IN THEIR TYPICAL LOCATION ON THE ENGINE. ACTUAL LOCATION MAY VARY WITH THE ENGINE ON YOUR UNIT. MUFFLER TOOLBOX DRIFT CUTTER SKID PLATE AUGERS FIG. 10 MEETS A.N.S.I. SAFETY REQUIREMENTS Our snow throwers conform to the standards of the American National Standards Institute. Toolbox - used to store spare shear bolts, locknuts and wrench. Drive speed control lever - used to select forward or reverse motion and speed of snow thrower. Safety ignition key - must be inserted for the engine to start and run. Remove when snow thrower is not in use. Traction drive control lever - used to engage powerpropelled forward or reverse motion of snow thrower. Electric start button - used for starting the engine. Recoil (auxiliary) starter handle - used for starting engine. Drift cutter - used to cut through deep snowdrifts. Primer - pumps additional fuel from the carburetor to the cylinder for use when starting a cold engine. Choke control - used for starting a cold engine. ON / OFF switch - used to STOP the engine. Auger control lever - used to engage auger motion (throw snow). Discharge chute control lever - used to change the direction the snow is thrown. Skid plate - used to adjust height of scraper bar from the ground. Deflector remote control lever - used to change the distance the snow is thrown. LH and RH turn triggers - used to steer the snow thrower. 9