Poulan PP8527ES User Manual - Page 8

OPERATION SAFETY IGNITION KEY SPARK PLUG CHOKE CONTROL ENGINE OIL CAP WITH DIPSTICK AUGER CONTROL LEVER GASOLINE FILLER CAP CHUTE DEFLECTOR THROTTLE / ENGINE CONTROL OIL DRAIN PLUG DISCHARGE CHUTE RECOIL (AUXILIARY) STARTER HANDLE PRIMER POWER CORD PLUG ELECTRIC START BUTTON FUEL SHUT-OFF VALVE CLEANOUT TOOL NOTE: ITEMS ABOVE ARE SHOWN IN THEIR TYPICAL LOCATION ON THE ENGINE. ACTUAL LOCATION MAY VARY WITH THE ENGINE ON YOUR UNIT. DRIVE SPEED CONTROL LEVER DISCHARGE CHUTE CONTROL LEVER TRACTION DRIVE CONTROL LEVER LIGHT HANDLE KNOB MUFFLER TOOLBOX AUGERS SKID PLATE FIG. 8 MEETS A.N.S.I. SAFETY REQUIREMENTS Our snow throwers conform to the standards of the American National Standards Institute. Toolbox - used to store spare shear bolts, locknuts and wrench. Throttle/engine control - used to select either FAST or SLOW engine speed and to STOP the engine. Safety ignition key - must be inserted for the engine to start and run. Remove when snow thrower is not in use. Traction drive control lever - used to engage power-propelled forward or reverse motion of snow thrower. Electric start button - used for starting the engine. Auger control lever - used to engage auger motion (throw Recoil (auxiliary) starter handle - used for starting the snow). engine. Discharge chute control lever - used to change the di- Primer - pumps additional fuel from the carburetor to the rection the snow is thrown. cylinder for use when starting a cold engine. Skid plate - used to adjust height of scraper bar from the Choke control - used for starting a cold engine. ground. 8