Poulan PPCRT17 Owner Manual - Page 4
Assembly
View all Poulan PPCRT17 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
ASSEMBLY Your new tiller has been assembled at the factory with exception of those parts left unassembled for shipping purposes. To ensure safe and proper operation of your tiller all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to insure proper tightness. TOOLS REQUIRED FOR ASSEMBLY A socket wrench set will make assembly easier. Standard wrench sizes are listed. (1) Utility knife (1) Wire cutter (1) Screwdriver (1) Tire pressure gauge (1) Pair of pliers (1) 9/16" wrench (2) 1/2" wrenches FRONT LEFT RIGHT overhead_views_1 OPERATOR'S POSITION (See Fig. 1) When right or left hand is mentioned in this manual, it means when you are in the operating position (standing behind tiller handles). OPERATOR'S POSITION Fig. 1 CONTENTS OF HARDWARE PACK (2) Handle Locks (1) Carriage Bolt 3/8-16 UNC x 1 Gr. 5 (1) Center Locknut 3/8-16 UNC (1) Flat Washer 13/32 x 1 x 11 Ga. (1) Cable Clip (1) Handle Lock Lever (2) Hairpin Clips (1) Pivot Bolt 3/8-16 UNC Grade 5 4 Extra Shear Pins & Clips