Poulan PRB675i Owner Manual - Page 8

• Examine the trigger for correct operation. • Examine the power button for correct operation. To install the battery pack To start the digital cruise control The digital cruise control lets you set and hold a blower speed without the trigger. 1. Hold the trigger at the necessary position and engage the digital cruise control. • Align the ribs of the battery pack with the slots in the battery compartment. Push the battery pack into the battery compartment until you hear a click. • To remove the battery pack, push and hold the battery release button and pull out the battery pack. To start the motor 1. Install the battery pack. See To install the battery pack on page 8. 2. Push the power button until the light is on. 3. Squeeze the trigger to operate. • Squeeze the trigger lightly for lower speed. • Squeeze the trigger more for higher speed. 4. Use the product. To stop the motor 1. Release the trigger. 2. Push the power button until the light is off. To change the power mode The power mode of the product can be changed while the product is in operation. There are 2 power modes: 1. Standard mode - Saves energy and maximizes run time. Standard mode is applicable for most tasks. Note: The product is set to Standard mode when started. 2. Boost mode - The product operates at high speed in Boost mode. Boost mode runs at maximum power for tasks that are not easy. To start Boost mode, push the Boost mode button until the light is on. To stop Boost mode, push the Boost mode button until the light is off. Note: If the trigger is released during operation, the product starts in the last mode. If the product automatically stops, or if the operator pushes the power button, the last used mode is erased from memory. The product is set to Standard mode again when started. 2. Release the trigger after the digital cruise control is engaged. Note: While the digital cruise control is engaged, the trigger can be pulled again to increase speed. After releasing the trigger, the digital cruise control reverts to its last position. 3. Disengage the digital cruise control to continue usual operation of the product. Power meter The power meter shows how much power the product uses during operation. • LED lights 4 and 5 show the best performance and best battery efficiency. • LED light 6 on the right side shows maximum power and the minimum battery efficiency. Battery state of charge LED The status of the battery pack is shown until you pull the trigger. When you release the trigger, the status of the battery pack is shown again. The number of LEDs that are on show the current charge level of the battery pack. LED lights All Green LEDs come on LED 1, 2 and 3 come on LED 1 and 2 come on LED 1 comes on LED 1 flashes Battery status Fully Charged (100% - 76%) The battery pack is 75% - 51% charged. The battery pack is 50% - 26% charged. The battery pack is 25% - 6% charged. The battery pack is 5% - 0% charged. Note: If the motor stops and the power LED stays on, push the button on the battery pack. For possible solutions, see TROUBLESHOOTING on page 9. 8 317 - 003 - 20.11.2017