Poulan PRB675i Owner Manual - Page 9

Note: When the battery pack is fully discharged, the motor stops immediately. the motor and battery pack cool. The product then resets. Note: The motor automatically stops if the battery pack or motor controller is too hot during heavy operation. Let MAINTENANCE WARNING: Read and understand the safety chapter before you clean, repair or do maintenance on the product. Maintenance schedule • Make sure that you obey the maintenance schedule. The intervals are calculated from daily use of the product. The intervals are different if you do not use the product each day. • Only do the maintenance work that is found in this manual. • Speak to an approved service center about other maintenance work not found in this manual. Daily maintenance • Remove the battery pack. Refer to the operating instructions of the battery pack for correct maintenance. • Examine the nuts, screws and bolts. • Examine the trigger for correct operation. • Examine the power button for correct operation. • Remove external unwanted material from the product with a soft brush or dry cloth. Do not clean with water, cleaning fluids, or solvents. • Use a soft brush to remove unwanted material from the air vents. • Examine the product for missing, damaged, loose or worn parts. • Examine the product to make sure the moving parts align and are safe for operation. • If the product is damaged, speak to an approved service center. Do not use a damaged product. TROUBLESHOOTING Problem The product does not start Possible cause Possible solution The power is off. Start the power. See To start the motor on page 8. No electrical contact between the product and battery pack. Install the battery pack correctly. See To install the battery pack on page 8. The battery pack is not charged. Charge the battery pack. See the operator's manual for the battery pack. The battery pack or product are Let the battery pack and product cool down before you start the too hot. product. The battery pack or product are Let the battery pack and product become warm before you start too cold. the product. Motor controller is too hot. Let the battery pack and product cool down for a minimum of 1 hour before you start the product. 317 - 003 - 20.11.2017 9