ProForm 150i Elliptical English Manual - Page 8

start all the Screws, and then tighten, them., Tip: Secure the Main Wire 32 to the Upright, with

Page 8 highlights

3. With the help of a second person, place some of the packing materials (not shown) under the rear 3 of the Frame (1). Attach the Track (11) to the Frame (1) with four M10 x 20mm Screws (74), two M10 x 38mm Screws (75), and six M10 Washers (64) as shown; start all the Screws, and then tighten them. Then, remove the packing materials from under the Frame (1). 74 64 1 74 11 74 64 75 4. Have a second person hold the Upright (2) near the Frame (1). 4 Locate the wire tie (A) in the Upright (2). Tie the lower end of the wire tie to the Main Wire (32). Then, pull the upper end of the wire tie until the Main Wire is routed through the Upright. Tip: Secure the Main Wire (32) to the Upright (2) with the wire tie (A) to prevent it from falling into the Upright. A 2 A 32 1 8

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28

8
3
1
74
74
74
11
64
64
75
4
1
2
A
A
32
3.
With the help of a second person, place some of
the packing materials (not shown) under the rear
of the Frame (1).
Attach the Track (11) to the Frame (1) with four
M10 x 20mm Screws (74), two M10 x 38mm
Screws (75), and six M10 Washers (64) as
shown;
start all the Screws, and then tighten
them.
Then, remove the packing materials from under
the Frame (1).
4.
Have a second person hold the Upright (2) near
the Frame (1).
Locate the wire tie (A) in the Upright (2). Tie the
lower end of the wire tie to the Main Wire (32).
Then, pull the upper end of the wire tie until the
Main Wire is routed through the Upright.
Tip: Secure the Main Wire (32) to the Upright
(2) with the wire tie (A) to prevent it from
falling into the Upright.