ProForm 380 Zlx Bike Uk Manual - Page 20
Maintenance And Troubleshooting
View all ProForm 380 Zlx Bike manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
MAINTENANCE AND TROUBLESHOOTING Inspect and properly tighten all parts of the exercise cycle regularly. Replace any worn parts immediately. To clean the exercise cycle, use a damp cloth and a small amount of mild soap-never use alcohol, abrasives, or chemicals to clean the exercise cycle. HOW TO ADJUST THE BELT If you can feel the pedals slip while you are pedaling, even when the resistance is at the highest level, the belt may need to be adjusted. IMPORTANT: To avoid damage to the console, keep liquids away from the console and keep the console out of direct sunlight. CONSOLE TROUBLESHOOTING If the console display becomes dim, the batteries should be replaced; most console problems are the result of low batteries. To replace the batteries, see assembly step 8 on page 9. If the console does not display your heart rate when you use the handgrip pulse sensor, see step 5 on page 16. To adjust the belt, you must first remove the right pedal and the right shield. Using an adjustable wrench, turn the right pedal clockwise and remove it. Next, remove the screws from the left and right shields; there are three sizes of screws in the shields-note which size of screw you remove from each hole. Then, gently remove the right shield. To tighten the belt, first loosen the M10 x 22mm Bolt (45). Next, tighten the M8 x 38mm Hex Screw (69) until the belt is tight. Then, retighten the M10 x 22mm Bolt (45). Reattach the right shield and the right pedal. HOW TO ADJUST THE REED SWITCH If the console does not display correct feedback, the reed switch should be adjusted. To adjust the reed switch, you must first remove the left pedal and the left shield. Using an adjustable wrench, turn the left pedal clockwise and remove it. Next, remove the screws from the left and right shields; there are three sizes of screws in the shields-note which size of screw you remove from each hole. Then, gently remove the left shield. Locate the Reed Switch (21). Turn the Right Crank Arm (54) until a Magnet (16) is aligned with the Reed Switch. Next, loosen, but do not remove, the indicated M4 x 16mm Flange Screw (61). Slide the Reed Switch slightly closer to or away from the Magnet, and then retighten the Flange Screw. Turn the Right Crank Arm Crank for a moment. Repeat these actions until the console displays correct feedback. When the Reed Switch is correctly adjusted, reattach the left shield and the left pedal. 45 69 16 54 21 61 20